Advertisement
Quick Links
New Step System Quick Installation Guide
Thank you for purchasing from National Ramp! This quick installation guide will cover how to install the new
step system.
Tools Required:
Impact Driver
Drill
3/8" socket
7/16" socket and/or wrench
9/16" socket
3/16" allen bit/wrench
¼" drill bit
Level
Pipe cutter/hacksaw/table saw (if cutting is required)
Sanding/Filing tool (to remove burs and sharp edges after cutting)
Advertisement
Related Manuals for National ramp New Step Breeze
Summary of Contents for National ramp New Step Breeze
- Page 1 New Step System Quick Installation Guide Thank you for purchasing from National Ramp! This quick installation guide will cover how to install the new step system. Tools Required: Impact Driver Drill 3/8” socket 7/16” socket and/or wrench ...
- Page 2 Instructions: 1. Insert two legs up through the leg receivers on the step assembly. Leg length will be dependent on rise of platform. Legs should extend above platform 12-18”. 2. Assemble two universal bracket assemblies, each assembly consisting of: One 3” universal bracket ...
- Page 3 3. Attach step assembly from step 1 to the platform – Line up the universal bracket assemblies from step 2 with the brackets on the leg receiver on the step assembly. Steps should be centered. 4. Ensure the legs inserted into the step assembly in step 1 is firmly grounded and lock the leg with a 3/8”-16 x ¾”...
- Page 4 5. Insert left and right step top posts over legs (from step 1). Note the longer rails from the top posts should point to the platform handrails and the shorter rails should point towards the steps. 6. Join upper and lower platform handrails with upper and lower rails from step top posts using elbows.
- Page 5 7. Measure and cut round tubes for step handrails. Make sure to remove any sharp edges after cutting. Join the cut handrails to the step upper and lower posts with elbows. There will be a total of 4 step handrails (two per side). 8.
- Page 6 9. Insert four plastic black square caps to top of step upper and lower posts. 10. Anchor left and right step base and legs plates to ground. Total of 12 anchors; 6 per side. Step installation is complete! Continue to step 11 if you are installing a gate.
- Page 7 Repeat for upper gate bracket. 13. Insert plastic black square cap to top of gate square tube on latch side. Test gate and latch functionality. Gate install complete!