Installation Of A New Plug N' Click Heater
Nyogel 760G (36308) and a stick
STEP 1 OPEN THE SYSTEM BOX
– Turn off power to the system.
– Using a Phillips screwdriver remove the
2 screws on top of the enclosure and open the cover.
STEP 3 REMOVE THE 2 HEATER SENSORS
– Locate the 2 sensors holder on the circuit board.
– Remove the 2 heater sensors by depressing the
clip and gently pulling on the wire to remove
each sensor cable.
Balboa Heater
PARTS AND TOOLS YOU NEED
– 3/8" (9.5mm) open end wrench
– 3/8" (9.5mm) nut driver
– Flat-head and Phillips screwdriver
– Replacement Balboa Heater
– Nyogel 760G (36308) and a stick
WARNING!
Please contact an electrician or your local electrical company when
connecting any spa electrical components. DO NOT OPEN THE SPA
SYSTEM AND ATTEMPT TO CONNECT THE CABLE CONNECTORS
YOURSELF. The high electrical voltage will harm or kill you.
STEP 2 UNPLUG HEATER CONNECTOR
– Unplug the heater power connector by depressing
the holder clip to release the female connector.
STEP 4 REMOVE NUTS ON HEATER
– Remove the 2 heater nuts with a 3/8" (9.5mm)
open wrench.
– Remove heater from system.