Audioplex IRBug Installation Manual

IRBug , IRFlood , TB-T, TB-S & TB-D, TB-HS & TB-HD
Connector:
Mounting:
Range:
Angle:
Wire:
These units are designed to act as remote repeaters of infrared controllers. They receive a signal from an IRTarget or
IRStation and mimic that signal to the device being controlled. This allows operation of any unit from any room in a
TM
structure equipped with IRTargets.
CAUTION: Take care to make sure that this unit is NOT IN THE LINE OF SIGHT OR REFLECTION with one of the
IRTarget. If radiation from the repeater is picked up by a system sensor, a feedback situation is created which will result in
instability and unreliable operation. Undesirable reflection can occur off the light colored walls, windows, mirrors, even shiny
wood finishes.
Any standard type wire can be used. These repeaters use 2 wires, so regular "zip" cord or telephone wire will be satisfactory.
Shielded or coaxial cable is not usually required unless the wire runs through some unusually high electrical interference
regions.
Be sure to observe polarity. These repeaters will not function if the wires are reversed.
NOTE: The TB-H series are high intensity units meant for larger rooms, or where the gang box is mounted severly off-angle.
Each unit contains 3 LED's which can be aimed by manually repositioning them. Please, do so with care.
Your AUDIOPLEX TECHNOLOGY Repeater is covered by a LIFETIME warranty against any defects in workmanship and
materials. Any defects will be remedied without charge for labor or parts.
Damage incurred by shipping or accident is not considered to be a defect, and not covered by this warranty. AUDIOPLEX
TECHNOLOGY , is not responsible for defective operation caused by abuse or by modification or service by any
unauthorized person or agency.
The unit must be properly installed and operated according to instructions for the warranty to apply. Any necessary servicing
must be done by AUDIOPLEX TECHNOLOGY . The products must be returned expenses prepaid, with written
authorization from the company. The unit must be shipped with the proof of purchase and in the original carton and packing
materials to avoid damage.
This warranty gives you specific legal rights. You may have other rights which vary from state to state.
INSTALLATION MANUAL
TECHNOLOGY
TM
TM
SPECIFICATIONS
Screw-type, 2 wire
IRBug: Directly to the front panel of each A/V component
IRFlood: Mount in front, above, below or to the side of components, can flash 2 or 3 units.
TB-T: Table top version
TB-S & TB-D, TB-HS & TB-HD: Fit most standard junction boxes.
10 -15 feet +, "H" models 30 - 40 feet (when used with Audioplex IRTargets).
+/-20-30 degrees off nominal axis. +/- 50-60 degres off axis.
Use conventional unshielded "zip" or telephone wire.
INSTALLATION
OPERATION
WARRANTY
TM