CaryMart 0010002 Manual

1500M 315Mhz or 433Mhz Wireless RF Signal Repeater (Model 0010002)
Package Include:
1 x Signal repeater: R-02
1 x User manual
Feature:
The signal repeater is a transceiver equipment that relays wireless RF signal. It receives weak wireless signal and then send out this wireless signal
with strong power to extend the transmission distance.
Two frequency versions are available: 315Mhz and 433Mhz, you need to choose same frequency for the repeater according to your signal.
Support three coding chips of the transmitter: EV1527, PT2262 and PT2240.
Support multiple signal modes: EV1527/180K, EV1527/300K, PT2262/1.2M, PT2262/2.2M, PT2262/3.3M, PT2262/4.7M, PT2240/1.5M, you need to
set the repeater to the corresponding mode according to your signal.
The repeater has learning function, it can learn and store 100 different transmitter signals.
The repeater can only relays signals that have already been learned, avoiding other unrelated signals.
Specification:
Working frequency: 315MHz / 433.92MHz
Working voltage: DC 12V
Standby current: 30mA
Working current: <255mA
Receiving sensitivity: -108dBm
Transmission power: 500mW
Transmission distance: 1500M in the open area
"POWER" LED: The power indicator.
"SEND" LED: The relay indicator. When the signal is relayed, the LED will illuminate.
8 Gang DIP switch: Each gang has on and off status, and the instruction as below,
1-gang: ON position = Signal of PT2262/1.2M; OFF position = No function.
2-gang: ON position = Signal of EV1527/180K, PT2262/2.2M or PT2240/1.5M; OFF position = No function.
3-gang: ON position = Signal of PT2262/3.3M; OFF position = No function.
4-gang: ON position = Signal of EV1527/300K, PT2262/4.7M; OFF position = No function.
5-gang: ON position = Signal transmission time 3~5 seconds; OFF position = Signal transmission time 1.5 seconds.
6-gang: ON position = Only relay signals that have been learned; OFF position = Relay all signals.
7-gang: ON position = Learning signal status; OFF position = Normal working status.
8-gang: ON position = Testing function (the repeater continuously transmits a signal of PT2262/1.2M; OFF position = Normal working status.
Operation:
1) Install two antennas to the repeater.
2) Connect to DV12V power supply to the repeater, and the "POWER" LED will be on.
3) Select the right signal mode by 1-gang to 4-gang. (Note: Only one gang can be set to the ON position at the same time.)
4) Learn the signals that need to be relayed: Turn 6-gang and 7-gang to ON Position, then trigger the transmitter, if the "SEND" ELD flashed twice, it
means learning is successful. After learning all transmitters, turn 7-gang to OFF position.
5) Put the repeater in the right position between transmitter and receiver.
Delete all transmitters:
If you don't want the repeater to work with the transmitter, you can delete all codes of transmitters, which are stored in the repeater.
Operation: Turn off the power of the repeater, and turn 7-gang and 8-gang to ON position, then turn on the power of the repeater, if the "SEND" LED
flashed 3 times, that means all stored codes have been deleted successfully.
SHENZHEN FLYING INDUSTRY DEVELOPMENT CO.,LTD
Http://www.carymart.com E-Mail: sale@carymarty.com