Page 1
02/2013 Mod: CSP/3.2E Production code: 40790002...
Page 2
USE AND MAINTENANCE INSTRUCTION MANUAL Cutter Blitz...
Page 3
CHAP. 7 - MAINTENANCE page 11 FOREWORD - GENERALITIES - FEET This manual has been drawn up to provide the customer with all information regarding the - POWER SUPPLY CABLE machine and the Standards connected to the same, as well as the use and maintenance - CUTTERS instructions that allow the object to be used in the best way possible, maintaining its efficiency through time.
CHAP. 1 – INFORMATION REGARDING THE MACHINE precise purpose of chopping, shredding, mixing, emulsifying, kneading food products (e.g. vegetables, meat, bread, etc.) and to guarantee: - maximum safety regarding use, cleaning and maintenance; 1.1 – GENERAL PRECAUTIONS The cutter must only be used by trained staff, which must be perfectly aware of the Safety - maximum hygiene, obtained thanks to a detailed selection of materials that come into contact with the food stuffs, and with the elimination of edges in the cutter that come into Standards contained in this manual.
Page 5
FIG. n°1 - General view of the machine 2.1 - CLEARANCE, WEIGHT, FEATURES ... FIG. n°2 – Dimensional drawings Optionals TAB. n°1 - CLEARANCE AND TECHNICAL SPECIFICATIONS Model U.m. Blitz Power Watt/Hp 370/0,5 Power supply 230V 50/60Hz F+N Tank capacity r.p.m.
Page 6
CHAP. 3 – RECEIPT OF THE MACHINE CHAP. 4 - INSTALLATION 3.1 – SHIPPING THE MACHINE (see FIG. n°3) 4.1 – POSITIONING THE MACHINE The cutter leaves our warehouses carefully packaged. The packaging is made up from: The surface on which the machine is situated must consider the dimension of support indicated in Tab.1 (on the basis of the model), and therefore be large enough;...
Page 7
the lid correspond to the relative latches on the tank 5.3 - SHARPENING THE CUTTERS ATTENTION: follow the instructions below to sharpen the two 3. At this point, activate the “ON” and “OFF” buttons cutters; to be performed as soon as reduced cutting is detected: 4.
Page 8
CHAP. 7 - MAINTENANCE 7.1 - GENERALITIES Before carrying out any maintenance operation: a) disconnect the plug from the socket in order to isolate the machine completely from the rest of the plant. 7.2 - FEET With time, the feet could deteriorate and lose elasticity, thus reducing machine stability. Replace them.