Quoizel IS-QR5137 Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, gloves, safety glasses, marking pen, 1/8" drill bit and drill.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the mirror. Contact your original place of purchase.
Warnings and Cautions
These instructions are provided for your safety. It is very important you read them completely before installing the mirror.
Package Contents
Mirror Hanger
A
x 2
Self-tapping Screw
B
x 4
Metal Part
C
x 2
-
Step 1 Identify Self-tapping Screws Locations for mounting the
Mirror Hangers By Using Template
The template included with package is provided to assist you in placing
the mirror in the location you desire. The template is a full size drawing
of your mirror and includes hanger mounting locations that your mirror
maybe hung.
Place the template on the wall in the location you have selected for
your mirror. Once you have the template in the location you desire and
making sure it is level you may tape or pin the template to the wall. Now
you may mark the holes for the mounting hardware as indicated on
your template. You may mark the mounting hardware location by either
using a pin and pushing it through the template leaving a small hole on
the wall. Or you may use a pencil and place a mark on the wall through
a small hole you cut into the template at the correct mounting location.
Remove the template from the wall and install the Mirror Hangers.
25.25"
2" Dia.
0.25" Dia.
11.75"
TEMPLATE
Mark Self-tapping Screws Locations
On The Wall Through (4) 0.25" Dia. Holes
2019 QuoizelInc.
for product cleaning tips. Go to the
20-30 minutes
D
E
22"
TOP
0.25"
28"
11.75"
0.75"
Figure 1
visit us on-line at www.quoizel.com
Installation Guide #IS-QR5137
For Style QR5137
Care + Maintenance selection.
-
STEP 2 Installing the 2 Mirror Hangers
Mirror
A. Using a 1/8" drill bit, drill holes at each (4) locations marked on the
x 1
wall surface.
B. Insert Wall Anchors (E) into drilled holes completely.
C. Using Self-tapping Screws (B) provided with the Mirror Hangers (A)
attach the 2 Mirror Hangers (A) to Wall Anchors (E).
Wall Anchor
x 4
-
STEP 3 Hanging the Mirror
A. Attach Metal Parts (C) onto axles on the sides of the Mirror (D) with
the cap end of Metal Part (C) against Mirror Hangers (A). By holding
Metal Parts (C) with Mirror (D) to hang the Mirror (D) to Mirror
Hangers (A) on the wall.
Clean glass with household glass cleaner. Retain this sheet for
future reference.
1of2
A
Mark
B
E
Figure 2
D
Cap End
Axle
Figure 3
ReleasedDate:2019-02-23
A
C