Perky-Pet Home Style Squirrel-Be-Gone II Quick Start Manual

To Install Hanger:
1. Remove lid by turning the chimney counter
clockwise and lifting up.
2. Insert the hanger end with the 3 bends (Fig. 1) into
the left side panel. There are two holes, insert into
the upper one. (Fig. 2)
3. Bring the other end of the hanger around the back
of the feeder as shown.
4. Place other hanger end into the single hole found
on the right side panel. (Fig. 3) Important Note:
To insert properly, you will have the hanger in a
down position, pointing to the back of the feeder
as shown.
5. While pushing the hanger into the hole, lift the
hanger into the upright position. You will notice
the end of the hanger on the left side panel,
springing out from the lower hole as indicated.
(Fig. 4) This will lock the hanger in an upright
position.
855-757-5973 | Woodstream Corporation | 69 N. Locust Street Lititz, PA 17543, USA
Home Style Squirrel-Be-Gone II
Model #339
See our full line of Perky-Pet ®
1.
3.
birdfeeders and accessories at www.perkypet.com
2.
4.
Pg. 1