Init NT-Retro-C Quick Setup Manual

Package contents
• 12" table fan
• Quick Setup Guide
Using your fan
Off/speed selection
The power switch is incorporated in the speed control switch on
the top of the fan.
0 - The fan is switched off.
1 - The fan operates at a low speed.
2 - The fan operates at a medium speed.
3 - The fan operates at a high speed.
Oscillation
To allow the fan to oscillate, push down the knob beside the fan
speed control. Pull up on the knob if you don't want it to oscillate.
Adjustment
To adjust the angle at which the fan is blowing
1 Loosen the adjustment knob under the fan motor.
2 Adjust the fan to the angle you want, then retighten the knob to
secure the fan at that angle.
Quick Setup Guide
12" Table Fan
NT-Retro-C/NT-Retro-S
Adjustment
knob
Features
Power switch/
speed selection
Oscillation
knob
Fan blade
Grill ring
Grill
Base
Servicing instructions
To replace the fuse
1 Unplug the fan.
2 Slide open the fuse access cover
on top of the AC power plug.
3 Remove the fuse.
4 Replace the fuse only with a 5A, 125 Volt fuse. Do not force the fuse
in place.
5 Slide the fuse access cover on top of the AC power plug closed.
Caution: Do not replace the AC power plug. Discard the product if the
plug is damaged.
Cleaning your fan
• Be sure to unplug your fan before cleaning.
• Plastic parts should be cleaned with mild soap and a damp cloth or
sponge. Thoroughly remove soap film with clear water.
• Be sure not to splash water or other liquid into the motor.