RDL D Series Installation & Operation

TWISTED PAIR FORMAT-A
Models D SERIES-BT1A
Wall-Mounted Bluetooth
y
Bluetooth Audio Input for Installed Sound System
y
Intuitive Single Button Pairing with LED Status Indication
y
Special Software Not Required for Module Setup
y
Customize the Module ID Name and Programming Password through the Bluetooth Connection
y
Sends Received Bluetooth Audio to RDL Format-A Receivers
The D SERIES-BT1A is part of the group of versatile wall-mounted products from Radio Design Labs. The standard mounting case can be directly fastened in North American electrical boxes or in RDL
International wall boxes.
The D SERIES-BT1A modules are Bluetooth audio receiving modules compatible with RDL® Format-A twisted pair receivers. When paired with a
APPLICATION:
compatible Bluetooth enabled devices, the module receives stereo audio from the Bluetooth source. The stereo signal is sent through two Format-A pairs to any RDL
Format-A receiver. A stereo/mono switch set by the installer permits summed mono audio to be sent over one switch-selected pair to the Format-A receiver.
If set for stereo operation, an additional Format-A source (set to Pair A) may be daisy chained with the D SERIES-BT1A to a three-pair Format-A receiver. If set for
mono operation, up to three D SERIES-BT1A modules may be daisy chained to a single three-pair Format-A receiver. Connections between Format-A modules and
Format-A receivers use standard CATx cable with RJ45 connectors.
The D SERIES-BT1A modules are powered from the Format-A receiver. The installer can customize the module name and programming password through the Bluetooth
connection using a smartphone, computer or tablet terminal program. These modules feature studio-quality circuits and analog filters to provide audio performance
exceeding expectations from consumer interface technologies. High performance, simplicity of operation and efficiency of installation make RDL the best value in
professional Bluetooth interfaces.
•
RDL 659 6th St.
Audio Format-A Interface
®
• •
Prescott, AZ., USA 86301
y
Mono Summed or Stereo Audio Input Mode is Switch-Selectable on Rear Panel
y
Rear-Panel Switch Selects which RJ45 Pair (A, B or C) is Fed in Mono Summed Mode
y
Daisy-Chain up to Three D SERIES-BT1A modules to One Format-A Receiver in Mono Mode
y
Remotely Powered through Twisted Pair Cable
y
Signal and Power Pair Pass-Through on RJ45 Jacks
•
(928) 443-9391 FAX (928) 443-9392
•
www.rdlnet.com