Eagletone EXTRA BALLS DISTORSION Operating Manual

DC socket
Output
LED
indicator
Level – Low – High – Gain
• The Level control adjusts the sound volume.
By turning it clockwise, the volume increases.
• The Low control adjusts the amount of bass frequencies.
By turning it clockwise, the bass frequencies increase.
• The High control adjusts the amount of treble frequencies.
By turning it clockwise, the treble frequencies increase.
• The Gain control adjusts the overdrive sound.
By turning clockwise, the overdrive increases.
Eq
Level

Comp
Level – EQ – Comp
• The Level control adjusts the sound volume.
By turning it clockwise, the volume increases.
• The EQ control adjusts the balance between low and high
frequencies. By turning it clockwise, the sound becomes
brighter.
• The Comp control adjusts the intensity of compression.
By turning it clockwise, the compression increases.
Input
Effect On/Off
switch
Eq
Level
Level Eq Level
Comp
Comp
Level
Level Feed
back
Delay
Time
Guitar effect pedal
operating manual
Commun instructions
• Plug the instrument into the input jack and connect the output jack
to your sound system or next effect unit.
• The LED indicator illuminates when the effect is enabled, and
extinguishes when the effect is bypassed.
• The pedal will toggle between Enable and Bypass with each
successive depression of the footswitch.
• The DC socket allows an external power source to the pedal.
The power pack must give 9V/DC (negative center) and must be
regulated.
Feed
Level
Feed
back
back
Delay
Delay Time
Time
Mode – Tone – Gain - Level
• The Mode Switch switches between normal (undulating
electricity sound) and crunch (boosts the dynamic range and
harmonic content of distortion) mode.
• The Tone control adjusts the Tone.
By turning it clockwise, the tone becomes high boost.
• The Gain control adjusts the distortion sound.
By turning it clockwise, the distortion increases.
• The Level control adjusts the sound volume.
By turning it clockwise, the volume increases.
Eq Level
Comp
Level – Feedback – Delay time
• The Level controls the amount of processing applied to the
signal. With the control set on the left, no signal processing
occurs and the signal is completely "dry".
With the control set on the right, "the original dry signal" and
"an equal level of delay signal" are given.
• The Feedback control governs the amount of processed signal
which is to produce multiple echoes from the original signal.
• The Delay time control adjusts the delay time.
By turning it clockwise, the delay time becomes longer.

Feed
back
Delay
Time