Vivotek AM-713 Quick Start Manual

VIVOTEK Mounting Accessories
AM-713 Junction Box
Installation Guide
Revison History:
Rev. 1.0: Initial release
Rev. 1.1: Added info. for EPoC application.
Rev. 1.2: Added surge protection connection.
I Compatible VIVOTEK Cameras
Compatible cameras/brackets
FD836B-HTV, FD836B-EHTV, FD836B-HVF2, FD836B-EHVF2, FD8382-TV, FD8382-ETV, FD8382-VF2, FD8382-EVF2, FD9381-HTV,
FD9381-EHTV, FD9371-HTV, FD9371-EHTV
Mounting Dimensions
51.00 51.00
5.20
Remove the dome cover and waterproof connectors.
5
Pass cables through the center hole on the top cover. Secure the
top cover by driving screws.
6
Part no.: 625031302G
Accessory Ordering part no.: 100138700G, AM-713_V01
EPoC junction box part no.: 100201400G
Package Contents
Pass cables through the routing holes and install the camera to box by
driving screws.
7
Connect cables to the Ethernet port and terminal block.
8
Installation
II
Remove the top cover and unhook the tether wire.
NOTE: If you have a POE extender or EPoC device, install them now.
Refer to the later section for details.
1
Attach the included alignment sticker to a preferred position. Drill holes
on the wall and install the junction box. If space behind the wall allows,
you may also pass cables through the wall.
2
Open a live view console and adjust the shooting direction. Refer to the
camera's QIG for more information.
Secure the camera top cover.
9
Optional Installation-1
You can also install a PoE extender (AP-FXC-0200) to the box.
A 3/4" conduit is required for routing the cables with waterproof
connection.
3
Install the cable gland and pass cables through it.
4
Attach a desiccant bag to the inside of the box. Note that the
installation should be completed within 30 minutes so that
desiccant remains effective.
Connect the PoE IN and PoE OUT cables.
Put tags on the cables marking their intended use.
PoE OUT
to another conduit
PoE IN
box
PoE OUT
to camera
RG6 1.2km
AW-FCT-050A-250
AP-FEX-0106-T
EPoC Tx Module
RG6 1.2km
PoE Switch Indoor EPoC
AP-FEX-0106-T
EPoC Tx Module