Kaboodle W-50560 Installation Manual

step 2
Follow these
instructions to
build and attach
your LED Driver
and Distributor
15W & 30W LED Driver (power supply) and distributor
Things you need to know
• When using an electrical appliance, basic safety precautions
should always be followed, including the following:
• Always read the instructions first before installation
• Not suitable for outdoor use
• Cut off the power source during the installation
• Don't bend the cables
• Keep proper ventilation around the unit and don't stack any
objects on it.
• Keep 10-15 cm of clearance when the device is close to a heat
source
• Check the information on the LED Driver label.
• Please consider the total wattage of all lights being joined
together and select the LED Driver that is greater than this total,
taking into consideration the following:
• 15w = max load 13.5w
• 30w = max load 27w
• 75w = max load 67.5w
Hardware included
A
10 mm screws x 2
Tools you will need
To put your kaboodle LED driver together you will need the following tools.
Cordless drill with:
• Number 2 screw tip
• 2mm drill bit Tape
measure Pencil
• If you have any questions, contact us on:
Australia: 1800 666 078 Monday to Friday between
8:00am and 6:00pm AEST, New Zealand: 0800 522 663
Monday to Friday between 8:00am and 5:00pm NZST
or email: info@kaboodlegroup.com.au.
• Caution: Risk of electrical shock and energy hazard. If product
fails to work, it should be examined by a qualified technician.
Do not remove the case of the LED driver.
• Do not install LED Driver in places with high ambient
temperature or close to fire source.
• Please refer to the specifications about the maximum ambient
temperature limitations.
• Output current and output wattage must not exceed the rated
values on the specifications
• If the LED Driver is damaged, the unit should be replaced.
Safety
gear
installation guide
Ver. 1
W-50560
W-50561
p. 1