Pem4 +spu3 system for t-sense® , tt-sense® and pt2 flowmeters (56 pages)
Summary of Contents for VAF instruments EVT-20
Page 1
An EVT-20 dongle is used for making the correct Interface board settings when an EVT-20 sensor is replaced. Please make sure that serial number on both the dongle and the new EVT-20 sensor are identical. For replacing the sensor we refer to our TIB-767-AL.
Page 2
STEP 5 Close EPC50 and the system is ready for use. The dongle can be disposed according to local rules after use.
Page 3
EVT-20 EVT-30 Interface board with DONGLE Interface board with MICRO SD-CARD Operating instruction EVT-30 – MICRO SD-CARD An EVT-30 micro sd-card is used for making the correct Interface board settings when an EVT-30 sensor is replaced. Please make sure that serial number on both the micro sd-card and the new EVT-30 sensor are identical.
Page 4
Please note that data is saved on the micro sd-card which may be used for future analyses. STEP 4 Place the new micro sd-card in the interface box in reverse direction when removing it. Follow step 2D – 2C – 2B – 2A STEP 5 Close the interface board in reverse direction when removing it in step 2.