k. Screen Installation
Straight Screen (w/return; w/o return), KSS__ J Screen, KSJ__ L Screen, KSL__
Parts List
Inner Clamp Bracket (A)
3AB1647
8-32 x ½" Truss
#14 x 1" Flat
Head Machine
Head Sheet Metal
Screw (E)
Screw (F)
3AB1622
7434100
k. screen
(Straight, J, or L configuration)
Pre-installed worksurface for screen
attachment
1. Review the dealer-supplied installation
documents to identify the size and
placement of the k. screen to be attached to
the worksurface. Match the size and
configuration (Straight, J, or L) to the
appropriate Installation Appendix A drawing
to determine the positions of required
worksurface edge drillings. Distances noted
are centerline dimensions. The Installation
Guide (J) should be placed on top of the
worksurface, pressed against the edge,
centered on the listed dimensions. Two holes
are to be marked on the worksurface edge
for each guide position.
2. Pre-drill the marked hole locations with a
9/64" drill bit. This step must not be skipped,
regardless of edgebanding material. Note:
veneer edgebanding will split if not pre-drilled
appropriately. Holes should be pre-drilled to
¾" depth. (Fig. 1)
November 2019
Outer Clamp
3/8" Desk Side
Bracket (B)
Bracket (C)
3AB1643
3AB164602
6-32 x ¼"
Extended Tip
Set Screw (G)
3AB1622
3. Note the difference in thickness between the
1¼" Desk Back Brackets (D) and the ³/
Desk Side Brackets (C). Position, in the
quantity required, the 1¼" Desk Back
Brackets (D) along the back edge of the
worksurface to align with the pre-drilled
holes. Attach the brackets to the
worksurface using (2) #14 x 1" Flat Head
Sheet Metal Screws (F) per bracket.
Fig. 1
Desk
Back
Bracket
(D) shown
installed
1¼" Desk Back
Bracket (D)
3AB164601
8mm Diameter
Drill Tube (H)
Installation Guide (J)
3AB4037
3AB4496
3.a If the screen is a J or L configuration
"
8
1¼" Desk
Back Bracket
(D)
#14 x 1"
Flat Head
Sheet Metal
Screw (F)
k. Screen Installation Instructions
Tools Needed:
Tape Measure
Installation Guide
Drill
Phillips #2 and #3 Bits
9/64" Drill Bit
1/16" Hex Allen Wrench
screen:
Position, in the quantity required, the 3/8"
Desk Side Brackets (C) along the side
edge of the worksurface to align with the
pre-drilled holes. Attach the brackets to
the worksurface with (2) #14 x 1" Flat
Head Sheet Metal Screws (F) per bracket.
Desk Side
Bracket (C)
shown installed
3/
" Desk Side
8
Bracket (C)
Part No. 3AB9099
Vertical
Channel (K)
3AB1597
Page 1 of 7