TCP SmartStuff SmartBox Quick Start Manual

NOTE: Please read the instructions before
proceeding with the installation.
WARNING: DANGER–RISK OF SHOCK–
DISCONNECT POWER BEFORE INSTALLATION!
NOTE: This device is suitable for damp
locations only.
• This product is used to control lighting luminaires with
0-10V dim to off drivers/ballast.
• This product must be installed in accordance with local
and national electrical codes. Please consult with a
qualified electrician before installation.
SmartBox + Panel Sensor Setting:
Microwave Maximum Height........ 10 feet / 3m
Microwave Maximum Diameter.... 33 feet / 10m
PIR Maximum Height .................... 10 feet / 3m
PIR Maximum Diameter............. 16 feet / 5.0m
Sensor Detection Angle.............................360°
Hold Time............................. 1 min. –1092 min.
Daylight Sensor Setpoint ............... 0 – 300 lux
Installation of the SmartBox + Panel Sensor
Check the label on
the SmartBox for correct
orientation and Install
as shown. The junction
box needs a 1/2" knock-
out for the SmartBox +
Panel Sensor to fit
securely. Use double-
sided tape if needed.
Electrical Connections
Make the electrical
connections as shown.
SmartBox +
Panel Sensor
TCP SmartStuff App
The TCP SmartStuff App is used to configure the Bluetooth®
Signal Mesh and TCP SmartStuff devices.
Download the TCP SmartStuff App using the following options:
• Download the SmartStuff App from the
Apple App Store or Google Play Store
• Use the QR Codes here:
Instructions for configuring TCP Smart App and SmartStuff
devices are at https://www.tcpi.com/tcp-smartstuff/
WARNING
½"
Luminaire Driver
DIM+ DIM- L N
purple gray
(22AWG) (22AWG)
black(18AWG)
white(18AWG)
SmartStuff SmartBox
Input Voltage
• 120 – 277VAC @ 15mA
Input Line Frequency
• 50/60Hz
Maximum Power
• 1W
Output Voltage
• 0-10VDC
Operating Temperature
• -23°F to 113°F
Switch between Microwave Sensor and PIR Sensor.
(120-277v)
L N
Maintain a minimum distance of 4.92 ft / 1.5m between:
• A window and the SmartBox + Panel Sensor.
• The SmartBox + Panel Sensor and other TCP SmartStu products with a Microwave Sensor.
Make sure no light is re ected in the direction of the SmartBox + Panel Sensor
LIMITED WARRANTY: This product is warranted for a period of 5
YEARS* from date of original purchase against defects in materials
and workmanship. If this product should fail to operate due to
defects in material or workmanship, simply call 1-800-771-9335 within
5 YEARS of purchase. This product will be repaired or replaced, at
TCP's option. This warranty is expressly limited to repair or replace-
ment of the product. This warranty gives the consumer specific legal
rights, which vary from state to state. WARRANTY IS VOID IF PROD-
UCT IS NOT USED FOR THE PURPOSE FOR WHICH THIS PRODUCT
IS MANUFACTURED.
+ Panel Sensor
Item Number: SMBOXPLBT
Specifications
Humidity
• <80% RH
Radio Protocol
• Bluetooth Signal Mesh
Communication Range
• 150 ft / 46 m
Regulatory Approvals
• ETL Listed
• Contains FCC ID: NIR-MESH8269
• Contains IC: 9486A-MESH8269
• Conforms to UL 8750
• Certified to CSA C22.2 No. 250.13
Microwave sensor PIR sensor