Advertisement
Quick Links
This Chevy Mounting Plate from Larson Electronics offers a no-drill mounting plate
solution for 2019 Chevrolet Silverado 1500 and GMC Sierra trucks (same trim) that
conveniently mounts to the rear cab light requiring no holes or modifications to be made
to the vehicle.
NOTE:
VIDEO GUIDES ARE AVAILABLE ON
Mounting the Plate
1.
Begin by removing the rear spoiler from the truck. This
involves removing the headliner. Consult manufacturer
information for further instruction on this process, or
consult a dealer or shop to install for you.
2.
Carefully remove the 4 screws holding the taillight
assembly in the spoiler using a Torx head driver.
3.
Unplug the wire harness to disconnect taillight from spoiler
4.
Depress the side of the plastic clips holding the taillight
assembly in the spoiler and push them through to free
the taillight from the spoiler.
5.
Inspect the gasket(s) of the mounting plate to ensure
surface is free of any defects or foreign material, then
line the plate up with the steps and mounting holes in
the spoiler.
MOUNTING PLATE INSTALLATION MANUAL
LARSONELECTRONICS.COM
UNDER THE PART NUMBER ON THE NAMEPLATE
screws
Advertisement
Summary of Contents for Larson Electronics VMP-GMC-SRA-2019-1500
- Page 1 MOUNTING PLATE INSTALLATION MANUAL This Chevy Mounting Plate from Larson Electronics offers a no-drill mounting plate solution for 2019 Chevrolet Silverado 1500 and GMC Sierra trucks (same trim) that conveniently mounts to the rear cab light requiring no holes or modifications to be made to the vehicle.
- Page 2 Feed the wiring back through the plate and spoiler and reconnect the harness to the spoiler. Push the plastic clips from the taillight assembly back through the holes in the spoiler to lock taillight back in place. Replace the 4 screws to secure the plate and taillight to the spoiler.