Larson Electronics GNM-LEDWL-25W Instruction Manual

Thank you for your purchase of the Larson Electronics GNM-LEDWL-25W series LED deck light. This light is
completely assembled, tested and ready for installation when shipped from the factory. Please follow the steps
below in order to operate and maintain this product.
IMPORTANT
READ CAREFULLY BEFORE OPERATING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. IF UNSURE ABOUT ANY PART OF THESE INSTRUCTIONS, CONSULT A QUALIFIED ELECTRICAL
PROFESSIONAL.
WARNING:
OPERATE ONLY AT THE VOLTAGE LISTED ON THE PRODUCT. DO NOT OPERATE IN CLOSE
PROXIMITY OF COMBUSTIBLE OR FLAMMABLE MATERIALS. NEVER LOOK DIRECTLY AT LIGHT WHEN ON. DO
NOT SHINE LIGHT INTO THE FACE OF SOMEONE ELSE.
WARNING:
CONSULT A QUALIFIED ELECTRICAL PROFESSIONAL/ELECTRICIAN TO INSTALL THIS DEVICE IN
ACCORDANCE WITH APPROPRIATE LOCAL AND NEC CODES AND REGULATIONS.
WARNING:
TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH APPROPRIATE ELECTRICAL CODES
AND REGULATIONS.
WARNING:
DEVICE
RECOMMENDED.
WARNING:
ALTHOUGH FIXTURE IS WATERPROOF, IT IS NOT DESIGNED OR INTENDED TO BE SUBMERGED.
WARNING:
DO NOT ALLOW LINE VOLTAGE WIRES TO BECOME SUBMERGED!
•
IP67 RATED; SUITABLE FOR WET LOCATIONS (ALTHOUGH FIXTURE IS WATERPROOF, IT IS NOT
DESIGNED OR INTENDED TO BE SUBMERGED).
•
ALL OUTDOOR INSTALLATIONS AND INDOOR INSTALLATIONS NEAR A WET LOCATION REQUIRE THE
USE OF A GFCI DEVICE FOR SAFETY, ACCORDING TO THE NATIONAL ELECTRICAL CODE® (NEC).
•
KEEP AWAY FROM FLAMMABLE OBJECTS. DO NOT POSITION WITHIN ONE (1) INCH OF ANY
COMBUSTIBLE MATERIALS.
•
IF DROPPED OR DAMAGED, THE UNIT MAY NO LONGER BE WATERPROOF AND SHOULD BE
REPLACED.
•
TO AVOID HAZARDS TO CHILDREN, ACCOUNT FOR ALL PARTS AND DESTROY PACKING MATERIALS.
•
PEOPLE WITH
ELECTROMAGNETIC FIELDS IN CLOSE PROXIMITY TO HEART PACEMAKER COULD CAUSE
PACEMAKER INTERFERENCE OR PACEMAKER FAILURE.
•
KEEP FINGERS AWAY FROM MAGNET WHEN MOUNTING AS INJURY COULD OCCUR.
INSTALLATION
MOUNTING
Mount to any flat metal surface capable of holding the weight of the light. It can be mounted in any direction.
When removing, do not drag the magnetic base to disconnect, as it may scratch the surface/paint. The magnet
provides 200lb. grip magnetic force.
LIGHT ADJUSTMENT
Position the flexible goose-neck at any angle and the lamp will hold its position. The double ball joint bracket
provides adjustability while keeping the goose-neck in place. Loosen the ball joint to rotate the light
tilt or pivot 180°. Tighten the ball joint once the desired position is achieved.
WIRING
Once mounted, check to ensure the deutsch connector is plugged into the back of the light and plug the unit
into the appropriate outlet providing the proper voltage listed on its product label. Improper voltage could cause
the unit to fail, voiding warranty. The light is "instant-on" and will turn on once power is supplied.
Voltage: 120-240V AC
Larson Electronics, LLC
GNM-LEDWL-25W Instruction Guide
LED Work Light w/ Goose Neck Magnetic Mount
IS SUITABLE FOR
PACEMAKERS SHOULD
Phone: (800) 369-6671
INSTALLATION IN WET
CONSULT THEIR
Fax: (903) 498-3364
GNM-LEDWL-25W
LOCATIONS; GFCI PROTECTION
PHYSICIAN(S) BEFORE
www.larsonelectronics.com
USE.
360° and
1 of 2