SUPPLEMENTAL INSTRUCTIONS
GB "Space Saving " Burner Assembly
Model Numbers
SSBA18N-S
SSBA18L-S
SSBA30N-S
SSBA30L-S
Component Parts
1. Gas Burner Pan
2. 3 in 1 Gas Valve
3. Thermocouple Assembly
4. Nat. Gas Orifice (Lp Air Mixer, Lp Gas Model)
5. Control Knob
6. Pilot Flame Adjustment
7. Gas Connection Fitting
CSA Models also have installed Gas Regulator
between Gas Connection Fitting and Valve
After completion of "To Install Gas Log Set"
Instructions in installation instructions, position
grate over Burner Assembly as shown in
(figure 2)
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR
EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF
LIFE.
1. This product has a standing pilot, which must be lit by hand. When lighting the pilot, follow these
instructions exactly.
2. This installation should be installed including provisions for combustion and ventilation air, must
conform with local codes or, in the absence of local codes, to the National Fuel Gas Code, Ansi
Z223 latest edition.
3. This product must be on gas supply line that is less than 1/2 psi. and with an individual manual
shut off.
4. Never operate this new system with the glass fireplace enclosures (doors) in the closed position.
5. Connecting 110-volt electrical power to this product will cause damage and will void warranty.
SSBA24N-S
SSBA24L-S
Model Numbers
A-SSBA18NS
A-SSBA18LS
A-SSBA30NS
A-SSBA30LS
4
1
( Figure 1 )
( Figure 2 )
A-SSBA24NS
A-SSBA24LS
7
3
2
6
5