Page 1
• To reduce the possibility of fire or explosion, be careful when working around gasoline. Keep cigarettes, sparks and flames away from all fuel-related parts. • DO NOT run the engine with the belt guard removed. 2/20/19 Champion Power Equipment, Inc.
Page 2
1. NOTICE: Cables are disconnected from the control handles and found near to the belt guard cover the front of the gas tank. 2. Remove bubble wrap and cable assembly ends will look as shown to the right. 2/20/19 Champion Power Equipment, Inc.
Page 3
Unscrew part A and B of the wire. 4. Place the drive control connector into the right handle as shown. This will be the cable that comes from the right side of the unit. 2/20/19 Champion Power Equipment, Inc.
Page 4
See ADJUSTING SELF-DRIVE CONTROL HANDLE CABLE in your manual for correct adjustments. 7. Repeat for the auger cable on the left side. 8. The cable will be located on the left side of the snowblower. 2/20/19 Champion Power Equipment, Inc.
Page 5
If you have any questions regarding the previous procedure, please contact our technical department Monday-Friday from 8:30 AM-5:00 PM PST at 877-338-0999. Champion Power Equipment, Inc. 12039 Smith Ave. Santa Fe Springs, CA 90670 Phone: 1-877-338-0999 Email: tech@championpowerequipment.com...
This manual is also suitable for:
100566100567100568060-3732060-3740060-3742...
Show all