Advertisement
Quick Links
www.sylvania.com
BACKlight 2
installation guide
(Bl02 and Bl04 Modules)
WARNING: ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION.
TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE, DISCONNECT POWER BEFORE ATTEMPTING
INSTALLATION OF THE POWER SUPPLIES AND/OR MODULES.
Failure to install the power supplies and/or LED modules in accordance with the National Electric Code (NEC), all applicable
Federal, State and local electric codes as well as the specific Underwriter's Laboratories (UL) safety standards for the
installation, location and application may cause serious personal injury, death, property damage and/or product malfunction.
These instructions are guidelines for installation of OSRAM LED modules and power supplies. Installation requirements may
vary depending on the application. Licensed electricians should provide all installation services for connection of both primary
and secondary (input/output) of the power supplies.
generation
nd
BACKlight 2
Generation modules from OSRAM
nd
SYLVANIA are durable, energy-efficient, and long-life
LED light source alternatives to neon. Their flexible,
chain configuration make them ideally suited to fit
contours and curves typical to channel letter signs.
The BL02 and BL04 LED modules are optimally oper-
ated with OPTOTRONIC
®
10.5Vdc power supplies.
This installation guide outlines step by step instruc-
tions to properly install both BACKlight BL02 and
BL04 modules for backlighting channel letters and
other signage applications.
Advertisement
Summary of Contents for Sylvania BACKlight 2nd Generation BL02
- Page 1 (Bl02 and Bl04 Modules) BACKlight 2 Generation modules from OSRAM SYLVANIA are durable, energy-efficient, and long-life LED light source alternatives to neon. Their flexible, chain configuration make them ideally suited to fit contours and curves typical to channel letter signs.
-
Page 2: Products Covered
Screwdriver manufacturer/owner if available • All power leads should have a • Tape measure • OSRAM SYLVANIA LED Specification minimum rating of 18 AWG • Drill and drill bits (3/32 drill bit Guide (LED028) or Product Inform- • Cable ties... -
Page 3: Power Supply Installation
installation steps: step step Material Check Power supply installation Verify that you have sufficient power supplies and LED modules on hand • Use 2 screws per power supply to to complete the project. DO NOT firmly secure the product in place. proceed with the installation if there •... -
Page 4: Power Supply
step step step led Wiring and Connect low Voltage Complete Power Connection to the Power Feed Wires to line Connection Power supply the Power supply leads • Connect the input power cable to the power line and verify proper operation. •... -
Page 5: Power Supply Requirements
APPendiX: 1. recommended Maximum oPtotroniC 10.5Vdc Power supplies remote Mounting distance Distance (ft) LED LOAD WATTAGE 14 AWG 16 AWG 18 AWG 20 AWG 22 AWG NOTE: The maxium remote mounting distance for OPTOTRONIC power supplies is specified in the power supply data sheets. Although it is possible to exceed these distances, the installer and/or end user must take precautions to prevent and/or test the effects of EMI (electromagnetic interference). - Page 6 Mississauga, ON L5S 1S4 Industrial Commercial Phone: 1-800-263-2852 Fax: 1-800-667-6772 Special Markets Phone: 1-800-265-2852 Fax: 1-800-667-6772 Visit our website: www.sylvania.com OPTOTRONIC and OSRAM are registered trademarks of OSRAM GmbH. SYLVANIA is a registered trademark of OSRAM SYLVANIA Inc. LED032R1 4/08...