Page 1
2 Inch Receiver: DT-ALBM6400, DT-ALBM6600, DT-ALBM6800, DT-ALBM7000 2.5 Inch Receiver: DT-ALBM6425, DT-ALBM6625, DT-ALBM6825, DT-ALBM7025 Congratulations on your purchase of a new Fastway® Flash™ ALBM ball mount. Read these instructions thoroughly to become familiar with proper set up and maintenance procedures. This will ensure that your Flash ball mount will give you maximum performance, and years of service.
Page 2
• Do not unlock the drop bar or ball holder while the ball mount IMPORTANT SAFETY INFORMATION is under load from an attached trailer. Failure to follow all safety warnings • Check all towing hardware before each trip. Do not tow your may result in severe injury or death.
Page 3
INSTRUCTIONS FOR USE 1. INSTALLING BALL MOUNT DROP BAR INTO Drop RECEIVER • Use the key to retract and extend the lock pins several times. Retract the lock pins. Insert the drop bar into the receiver. Make Equal sure the lock pins align with the hitch pin holes in the receiver tube.
Page 4
Fastway product. In no event shall Fastway Trailer Products be liable for any damages other than the replacement or repair of the affected part. Authorization and warranty procedure may be obtained by calling Fastway Trailer Products customer support at 877-523-9103.
This manual is also suitable for:
Flash dt-albm6400Flash dt-albm6600Flash dt-albm6800Flash dt-albm7000Flash dt-albm6425Flash dt-albm6625...
Show all