LOOP Q REEL Series Manual

LOOP Q REEL MANUAL MODEL 4/6 - 6/8 - 7/9
THIS FLY REEL IS A QUALITY product from the LOOP tackle assortment of
fly fishing gear. The design, craftmanship and testing behind this reel are
all on the cutting edge of fly fishing product development. As a part of our
commitment, our sta of anglers are constantly on the water designing,
using, adjusting and perfecting the gear. We at LOOP are uniquely able to
do this because our capabilities extend well beyond just manufacturing.
For more information about this fly reel and the complete line of LOOP
tackle and gear, please visit us at looptackle.com.
1 6 7 8 9
2 24 33 5
1. Drag knob 11. Frame
2. Locking screw 12. Foot
3. Draw nut 13. Foot screw
4. O-ring 14. Spool cover
5. Draw bar washer 15. Clicker plate
6. Clicker bush 16. Seal ring
7. Clicker pin 17. Ball bearing
8. Clicker spring 18. Disc washer
9. Stop pin
19. Ball bearing
10. Main shaft 20. One way clutch ass'y
LOOP Tackle Design AB Sweden
Ph: +46 (0)8 544 101 90
E: info@looptackle.se
13
12
11 8 7 6
10 15 16 17
21. Brake disc 31. Handle knob
22. Bearing holder 32. Handle knob screw
23. Spring washer 33. O-ring
24. Draw bar 34. Bearing Washer
25. Spool
26. O-ring
27. Spool cap
28. Handle shaft/Spool cover screw
29. Handle shaft
30. Handle knob washer
MAINTENANCE OF THE REEL:
• This reel is contructed so that maintenance is kept to a minimum.
However, be sure to check on the level of grease on the O-ring (26)
inside the spool cap (27), after using the reel for some time. We
recommend Molykote 111C grease or similar.
• Put grease on locking screws #2 and the threads on drag knob #1
before use in saltwater.
• Rinse reel after use in saltwater. Do not remove the spool, water may
penetrate the drag system.
• After fishing or when stored, make sure to release the pressure on the
drag system.
CAUTION! Do not touch any moving parts of the reel when a fish is running.
18 23
20
21 22 19 34 23
CONVERSION LEFT/RIGHT HAND RETRIEVE:
1. Rotate spoolcap (27) anticlockwise to release spool
2. Pull spool (25) straight out
3. Release stopscrews (2) ½ turn with enclosed Allen wrench
4. Pull drag knob (1) straight out
5. Rotate draw bar(24) anticlockwise with flat screwdriver and remove
draw bar nut (3)
6. Pull bearing holder (22), with internal, straight out
7. Remove and turn the clicker plate (15)
8. Remove seal ring (16)
9. Remove cup springs (23), bearing (17), disc washer (18), carbon brake
disc (21) and one way clutch assy (20
10. Turn one way clutch assy (20)
11. Wipe clean
12. Assemble the reverse way
25
3 28
28 26
29 30 31 32
27 4 14