Early Childhood Resources ELR-0822 Manual

Porcelain DE Board
Mount Laurel,NJ 08054 USA Model # ELR-0822, 0823, 0825, 0827, 0828, 0829, 0830
www.ecr4kids.com
!
WARNING:
- Adult Assembly Required. Two adults recommended.
- Contains small parts, sharp points and edges.
- Do not climb, lean or pull on unit or support.
- Never leave children unattended.
- Do not place unit near high heat or moisture.
- Adult Supervision Recommended.
Parts List : Before assembling, make sure there are no missing parts for the applicable model #.
ELR-0830 48"x144" 16PCS 16PCS
48"x120" 16PCS 16PCS
ELR-0829
48"x96"
16PCS 16PCS
ELR-0828
48"x72" 12PCS 12PCS
ELR-0827
48"x48"
ELR-0825
8PCS 8PCS
36"x48" 8PCS 8PCS
ELR-0823
24"x36"
ELR-0822 8PCS 8PCS
Model #
Board size
Phillips screw
Anchor
4PCS 4PCS 1PC 8PCS
4PCS 4PCS 1PC 8PCS
4PCS 4PCS 8PCS
1PC
3PCS 3PCS 1PC 6PCS
2PCS 2PCS
1PC 4PCS
2PCS
2PCS 1PC 4PCS
2PCS
2PCS 1PC 4PCS
Top hanger
Bottom hanger Allen wrench Washer
1
2
3
5PCS 1PC 4PCS 4PCS
2PCS 1PC 4PCS 4PCS
2PCS 1PC 4PCS 4PCS
2PCS 3PCS 3PCS
1PC
3PCS 2PCS 2PCS
1PC
3PCS 1PC 2PCS 2PCS
3PCS 2PCS 2PCS
1PC
Installed top
Installed bottom
Small screws Pen tray
brackets
brackets
Attaching the bottom hangers
Figure 1
1-A With the help of 2 other people, position the board on the wall, approximately
4" above where you want to mount it. Place the bottom hangers upside down
on the pre-installed bottom brackets. Use a pencil to mark the position of the
holes in the bottom hangers.
1-B Remove board from the wall. Drill 1/4" diameter holes where marked and insert
an anchor into each hole. Align the holes in the bottom hangers with anchors
and secure with the Phillips screws.
Attaching the top hangers - Part 1
2-A With the help of 2 people, place the pre-installed bottom brackets into the
bottom hooks on the wall. Push the board against the wall.
2-B Place the top hangers into the pre-installed top brackets as shown in Figure 2.
Use a pencil to mark the top and right side position of the top hangers - as
shown in Figure 2.
Figure 2
Attaching the top hangers - Part 2
Hole 2
Hole 1
3-A Remove the board from the wall and place the top hanger in the marked
position on the wall-use a pencil to mark the holes. See figure 3.
3-B Drill 1/4" diameter holes where marked and insert an anchor into each hole.
Align the holes in the top hangers with anchors and secure with washers
and Phillips screws.
Version: ELR-0822-0830_AI.F.2010.01.01
Figure 3