Hide thumbs Also See for MxPro 5:

Advertisement

Printer
The operation and functions described in this manual are available from Software Version Mx5000-050-02 onwards.
www.advancedco.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MxPro 5 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Advanced MxPro 5

  • Page 1 Printer The operation and functions described in this manual are available from Software Version Mx5000-050-02 onwards. www.advancedco.com...
  • Page 2 Specifications: Models, Sales Order Parts: Mxp-512 Mx-5000 Internal Printer Applications / Limitations: When the printer is fitted, only four of the eight key-switch positions can be used. Compatibility: All Mx-5000 Series Panels except Mx-5101S. The printer fully supports the complete Western European character set – Code Page 1252. It is possible to support other code pages.
  • Page 3: Table Of Contents

    Table of Contents Page INTRODUCTION............................. 3 INSTALLATION .............................. 4 ......................4 OUNTING THE PRINTER ASSEMBLY ..........................5 ABLE NSTALLATION ........................6 NSTALLING THE PAPER ROLL ..........................6 ROGRAMMING LED .............................. 6 AULT CONFIGURATION ............................7 OPERATION ..............................8 ............................8 RINT ..............................
  • Page 4: Installation

    2 Installation Isolate ALL sources of power before installing or removing printed circuit boards. Observe anti-static precautions at all times when handling printed circuit boards. 2.1 Mounting the printer assembly The printer is mounted onto the display plate in a pre-defined aperture. To Base Card Printer...
  • Page 5: Cable Installation

    Fixing Door release flap holes 2.2 Cable Installation Remove the existing ribbon cable between the display and the base card. The supplied cable is provided with three connectors. Plug one connector into the display card and then plug the second connector into the printer. Route the cable through the clamp and plug into the connector on the base card (ensure that the heat shrink protection is in place under the tabs on the base card chassis plate.
  • Page 6: Installing The Paper Roll

    2.3 Installing the paper roll Using the door release flap, open the paper roll aperture door. Insert the roll so that the paper exits from the top as shown over the top of the roller. Close and snap shut the door. Tear off any excess paper using the tear-off strip.
  • Page 7: Configuration

    3 Configuration To configure and test the printer, select the printer options from the main level 2 menu. [Print Menu] INPUTS OUTPUTS FAULTS DISABLED FEED PAPER SETUP-PRINTER Use the  buttons to highlight and select the “SETUP-PRINTER” option Use the  buttons to highlight and press ✔ to select the “Internal” option. (Note: If required the panel will support simultaneous printing to an external printer too, but the “wide”...
  • Page 8: Operation

    These defaults can be changed as required. Use the arrow and number keys to select and enter the required zone numbers. It is possible to feed the paper using the FEED PAPER menu option. The paper can also be advanced using the button on the front of the printer.
  • Page 9 USER NOTES www.advancedco.com...
  • Page 10 Doc Number: 680-193 Revision: Advanced Electronics Ltd Moorland Way, Cramlington, Northumberland, NE23 1WE UK First Issued: 2013-mm-dd Tel: +44 (0)1670 707 111 Fax: +44 (0)1670 707 222 Email: sales@advancedco.com Web: www.advancedco.com www.advancedco.com...

This manual is also suitable for:

Mxp-512Mxpro5

Table of Contents

Save PDF