Nortek Security & Control DOOR GARD 212R Wiring Diagrams & Specifi Cations

212R & 212SE Wiring Diagrams
TECHNICAL NOTES
● To avoid ESD (Electro-Static Discharge) interfering with the
operation of the keypad, ground the housing to earth ground.
● The bi-color LED provided with the SE keypad illuminates red when
the Lock-Release relay is de-energized and green when the relay is
de-energized.
When mounting this unit outside, apply silicone to the area where
●
the wires enter the case. This helps prevent water from entering
the case and condensing on the circuit board. Do not silicone the
cover plate because the unit will not seal properly.
● Do not seal the drain holes at the bottom of the keypad housing.
This allows air to circulate and a place for condensation to drain.
For use in extreme weather conditions, consult the factory for
●
additional methods of protecting your keypad.
To speed installation of the SE keypad, holes have been spotted on
●
the inside the back housing for mounting to a wall or a single-gang
electrical box.
On SE keypad, holes have also been spotted inside the front
●
housing for additional LEDs (LEDs not included).
LIMITED WARRANTY
This Nortek Security & Control product is warranted against defects in
material and workmanship for twenty four (24) months. This warranty
extends only to wholesale customers who buy direct from Nortek
Security & Control or through Nortek Security & Control's normal
distribution channels. Nortek Security & Control does not warrant this
product to consumers. Consumers should inquire from their selling
dealer as to the nature of the dealer's warranty, if any. There are no
obligations or liabilities on the part of Nortek Security & Control
LLC for consequential damages arising out of or in connection with
use or performance of this product or other indirect damages with
6-062120 X2
Wiring Diagrams & Specifi cations
Note: This product is designed to be installed and serviced
by security and lock industry professionals.
SPECIFICATIONS
Case Dimensions:
212R Keypad: 3.75" W x 5.25" H x 2.50" D
212SE Keypad: 3.00" W x 4.50" H x 1.55" D
Operating Voltage: 12-24V AC/DC (Auto-Adjusting)
Maximum Current Draw
Operating Voltage
12 VDC
24 VDC
12 VAC
24 VAC
Main Relay Contacts (K1): 2A @ 12-24V AC/DC
Auxiliary Relay Contacts
(K2, K3 & K4): 1A @ 12-24V AC/DC
Environment: Indoor or Outdoor
Temperature: -31°F to 151°F (-35°C to 66°C)
respect to loss of property, revenue, or profi t, or cost of removal,
installation, or reinstallation. All implied warranties, including implied
warranties for merchantability and implied warranties for fi tness, are valid
only until the warranty expires. This Nortek Security & Control LLC
Warranty is in lieu of all other warranties express or implied.
All products returned for warranty service require a Return Authorization
Number (RA#). Contact Returns at 1-855-546-3351 for an RA# and other
important details.
212R & 212SE Keypad
Current
50 mA
63 mA
86 mA
108 mA
1