Legacy Whirlpool Enterprise SE Quick Start Manual

LEGACY SPA - CONTROLS
Enterprise SE & Inspire SE
InItIal Start-up
When your spa is first actuated, it will go into Priming mode, indicated by
" " The Priming mode will last for less than 5 minutes (press "Warm" or
"Cool" to skip Priming mode) the spa will begin to heat and maintain the
water temperature in the Standard mode.
Warm / Cool (80˚F-104˚F / 26˚C-40˚C)
The start-up temperature is set at 100 degrees F / 37 degrees C. The last
measured temperature is constantly displayed on the LCD display.
1 pump System
To display the set temperature, press the "Warm" or "Cool" button once.
To change the set temperature, press the button a second time before the
LCD stops flashing. Each press of the "Warm" or "Cool" button will continue
to either raise or lower the set temperature.
2 pump System
To display the set temperature, press the "Temp" pad once. To change
temperature, press the pad a second time before the LCD stops flashing.
Each press of the "Temp" pad will continue to either raise or lower the set
temperature.
If the opposite direction is desired, release the pad and let the
display revert to the current water temperature. Press the pad to display
the set temperature, and again to make the temperature change in the
desired direction.
After three seconds, the LCD will stop flashing and display the current
spa temperature.
Jets
Press the jets button once to activate the pump on low speed. Press the jets
button again to turn the pump on high speed. If left running on low speed
the pump will automatically turn off after 4 hours, and the high speed will
automatically turn off after 15 minutes.
1
LEGACY SPA - CONTROLS
Enterprise SE & Inspire SE
light
Press the "Light" button to turn the light on and off. If left on, the light
automatically turns off after 4 hours.
Mode
Mode is changed by pressing the "Temperature" button (Warm or Cool on some
models) and then the "Light" button to cycle through the different modes.
Standard Mode is programmed to maintain the desired temperature. Note
that the last measured spa temperature displayed is current only when the
low speed of pump 1 has been running for at least 2 minutes. "
displayed momentarily when you switch into the Standard Mode.
Economy Mode heats the spa to the set temperature only during filter cycles.
" " will display solid when temperature is not current, and will alternate
with temperature when temperature is current.
Sleep Mode heats the spa to within 20°F/10°C of the set temperature only
during filter cycles. " " will display solid when temperature is not current,
and will alternate with temperature when temperature is current.
preset Filter Cycles
The first filter cycle begins 6 minutes after the spa is energized. The second filter
cycle begins 12 hours later. Filter duration is programmable for 2, 4, 6, 8 hours
or for continuous filtration (indicated by "
hours.
To program press the "temperature" button (Warm or Cool button on some
models) then the "Jets" button to adjust. Press "Jets" to exit programming.
At the beginning of each filter cycle the pump(s) purge for 30 seconds. The only
effect filter duration has is: 1) During the filter cycle, the low speed of pump 1
never turns off. 2) In Economy and Sleep modes, heating only occurs during the
filter cycle.
Freeze protection
If the temperature sensors detect a drop to below 44°F/6.7°C within the
heater, the pump will automatically activate to provide freeze protection.
The equipment stays on until 4 minutes after the sensors detect that the spa
temperature has risen to 45°F/7.2°C or higher. In colder climates, an optional
additional freeze sensor may be added to protect against freeze conditions
that may not be sensed by the standard sensors. Aux freeze sensor protection
acts similarly except with the temperature thresholds determined by the switch
and without a 4-minute delay in turnoff. See your dealer for details.
" will be
"). The default filter time is 2
2