FLUXWERX nLight VN1 Install Instructions

1
UNCOIL CABLE + INSTALL FIXTURE
RAILS
INBOX
1. Uncoil sensor cable from top of fi xture.
2. Install the fi xture per standard installation instructions.
2
PREPARE SENSOR LOCATION
1. Determine sensor location per site design instructions and/or
Enlighted design instructions. Note that the sensor cable overall
length is approximately 5 feet.
All rights reserved. © Fluxwerx Illumination 2020
Due to continuous product improvements, specifi cations and dimensions are subject to change without notice. Certain options have
limited compatibility with some other product selections. Consult www.fl uxwerx.com for most current technical information.
604.549.9379 | fl uxwerx.com
instruction
RECESSED CONTROLS:
REMOTE ENLIGHTED SENSOR (RE1)
Enlighted Micro Sensor SU-5E-CL
LOOP RECESSED
TRANSOM
2. Drill a 13/16" diameter hole in the ceiling tile at the desired location.
3. Insert the sensor tile mount base into the ceiling tile hole.
install
PAGE 1 of 3
Install-Controls-Recessed | 2020-03