BULK REEF SUPPLY 100W Operating Manual

GROUNDED
POWER PLUG
CORD
MODEL WATER VOLUME
100W UP TO 40G
200W UP TO 75G
300W UP TO 100G
600W UP TO 200G
Read this operating manual completely through before using the heating element. Keep this manual where it is safe and accessible.
If you make the heating element available to a third party, provide this operating manual along with the heating element. Failure to
comply with the instructions in this manual can result in personal injury and material damage. We assume no liability whatsoever for
personal injury and material damage due to failure to comply with the instructions in this operating manual.
Note/Caution: this heater is for aquarium use only and requires a temperature controller
OPERATION
Unpack the entire contents and ensure that the heater and accessories are complete and undamaged. If any damage or
defects are identified, please contact Bulk Reef Supply immediately.
1
Ensure that the power of the heating element is appropriate for the volume of water that will be heated.
2
Pay attention to the minimum immersion depth when installing. The element can be damaged if it is not
completely surrounded by water. Note the minimum water level marker when installing vertically; this is
the minimum point to which the heating element must be immersed in the water. For horizontal installation,
ensure that the heating element is always fully immersed.
3
Slide the supplied suction cup holders onto the heating element.
4
It is possible to attach the heating element in any desired position below the surface of the water, using the
supplied suction cup attachments. Press the heating element with the holders into the desired position on
a clean surface of your sump or aquarium. Note: The suction cups do not adhere to uneven, dirty surfaces,
and the heater may fall off. Surfaces and equipment can be damaged from prolonged direct contact with
the heating element.
5
Plug the power plug of the heating element into a suitable temperature controller.
TITANIUM HEATER
IMMERSION
CAP
DEPTH MARKER
6 FEET
ELEMENT LENGTH/DIAMETER
10.25" / 1"
10.25" / 1"
10.25" / 1"
14" / 1"
100W | 200W | 300W | 600W
CORROSION
RESISTANT TITANIUM
MINIMUM
MAXIMUM WATER IMMERSION DEPTH: 4'
CABLE LENGTH: 6'
LINE VOLTAGE: 110 V/60 Hz
PROTECTION CLASS: IP 68
SUCTION
CUP MOUNTS