Harmopool ZFPX5200 Manual

Whirlpool bath pump

Advertisement

Quick Links

Manual
Harmopool Whirlpool Bath Pump:
ZFPX5200 -ZFPX5210 - ZFPX5220
Imported by:
Zwembad BVBA
Industrieweg 9
3190 Boortmeerbeek
België
www.harmopool.eu

Advertisement

Table of Contents
loading

Summary of Contents for Harmopool ZFPX5200

  • Page 1 Manual Harmopool Whirlpool Bath Pump: ZFPX5200 -ZFPX5210 - ZFPX5220 Imported by: Zwembad BVBA Industrieweg 9 3190 Boortmeerbeek België www.harmopool.eu...
  • Page 2: Table Of Contents

    Table of content Safety instructions ........................3 General information ........................ 3 Installation ..........................4 Assembly ..........................4 Electricity ..........................4 Controls prior to first start-up ....................5 Start-up ............................ 5 Maintenance ..........................5 FAQ ............................6 Appendices ..........................7...
  • Page 3: Safety Instructions

    Safety instructions When installing and using this electrical equipment, basic safety precautions should always be followed, including the following: ○ READ THE MANUAL AND FOLLOW THE INSTRUCTIONS ○ In order to reduce the risk of injuries, children are not allowed to use the device without strict supervision.
  • Page 4: Installation

    Installation ○ The pump should be located in an area with good ventilation. Dimensions and position of the pump for supporting and fixing the pump within this space can be found on Figure ○ Pump must be fixed by screws on the tub shelf, and fixed with silent block to lower the noise and liberation.
  • Page 5: Controls Prior To First Start-Up

    Controls prior to first start-up 1. Verify that the pump shaft turns freely. 2. Check whether the voltage and frequency are according to the name plate. 3. The Hydro massage assembly should be equipped with a system to prevent the pump from starting up if a minimum water level is not present.
  • Page 6: Faq

    SYMPTOM POSSIBLE CAUSE CHECK -Incoming power to the pump? -Is circuit breaker on? -Is GFCL operating NO POWER PUMP properly? DOES -Is the air switch TURN plugged in? -Is the air switch hose connected to the AIR SWITCH DISCONNECTED pump? -Is the air switch hose connected to the actuator button on...
  • Page 7: Appendices

    Appendices Figure 1: Installation with connection pipe, drain and minimum water level Figure 2: Measurements and technical specifications Model Kracht (P1) ZFPX5200 0.25 0.35 152.5 32.5 ZFPX5210 0.37 0.50 ZFPX5220 0.55 0.75 152.5 43.5...
  • Page 8 Figuur 3: Performance curves Model Zwembad BVBA internal code JA35 ZFPX5200 JA50 ZFPX5210 JA75 ZFPX5220...

This manual is also suitable for:

Zfpx5210Zfpx5220

Table of Contents