Advertisement
Quick Links
Sump Pump
Installation and
Operating Instructions
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they don't play with appliance.
CAUTION: This pump MUST be installed with a suitable earth leakage circuit
breaker (E.L.C.B.) or residual current device (R.C.D.) with a rated residual operating
current <30mA.
These Instructions must be delivered with the pump to the operator.
The oil in the seal chamber should be periodically checked and replaced. This work should be done
by a suitably qualified Service Dealer every 2,000hrs of operation or every 12 months, whichever
occurs first.
TotalFlo
MODELS
VORTEX: TF180S & TF230S
Suffix:
M = Manual
Voltage: 220/240V 50Hz Single Phase
Max. Total Head: TF180S = 5m
TF230S = 8m
™
Advertisement
Summary of Contents for Davey Water Products TotalFlo TF180S
- Page 1 TotalFlo ™ Sump Pump Installation and Operating Instructions This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they don’t play with appliance.
- Page 2 Installation & Operating Instructions The TotalFlo range of Submersible Sump Pumps are suitable for pumping small soft solids (up to 18mm Max.) in fluid suspension. They are extremely quiet in operation which makes them ideal for applications within residential areas for sullage pits, waterfalls and general drainage. Other Ideal Applications are: Lift Wells, Car Park Sumps, Basements, Cable Pits, etc. This Submersible pump has been factory checked prior to delivery; however, please check for any damage during transport. After Sales Service is available from your TotalFlo reseller. DO NOT: Run the pump dry. Attempt electrical repairs, unless qualified to do so. Run the pump with the motor fully exposed for long periods. Install the pump on soft or loose ground. Operate the pump if the inlet is submersed by sand or debris.
- Page 3 NOTE: 1. Long extension leads should be avoided as they often have insufficient current carrying capacity to run electric motors, hence they can cause substantial voltage drop and operating problems. 2. Minimum voltage at the electric motor must not fall below 216 Volts for single phase, otherwise motor damage may result which is not claimable under guarantee.
- Page 4 A Quick Reference Guide is included with the product when purchased new and for detailed Installation and Operating Instructions please visit TOTALFLOPUMPS.COM. This warranty is given by Davey Water Products Pty Ltd. For further information, please contact us at: TotalFlo ™...