Nola Parco Ö19-20 Assembly Instructions Manual

560
450
250
Ö19-20 Parco armchair
Ö19-22 Parco swivel armchair
Leveransspecifikation:
1 seat
1 support post (with fixed support post or swivel
4 screws and washers for attaching the seat and
backrest to the supporting post.
Add a letter after the product code to specify the version
required, for example
Ö19-20 A :
A = Armrests (Ö19-20 and Ö19-22 versions only)
M = Ground-mounted armchair with extended support post for
casting in concrete 40 cm beneath the surface
N = Attachable version with base edge extended for bolting
into the surface
509
ARMCHAIR ASSEMBLY INSTRUCTIONS/
Turn the armchair upside down, being careful to protect
the wooden parts during installation. Using a screwdriver
with an H6 bit, secure the supporting post to the
underside of the seat with the screws and washers
included (MK6S M10x16 + FBB M10).
Installation with M10 bolts ('N' version):
The base plate has been made with holes to secure it to
the surfaces with M10 bolts.
Installation on a wooden surface ('N' version): Use
French-style woodscrews to attach the base plate to the
wood.
Installation on cobbles or paving stones ('N' version):
Anchor the cobbles or paving stones in a cast concrete
509
base without allowing any levelling sand to come
between the stones and the concrete. Drill holes in the
surface sized to accommodate expander bolts. A
chemical anchor may also be used.
Installation on concrete ('N' version): Attach with
expander bolts or a chemical anchor as instructed
above. Attaching with expander bolts makes it possible
to remove and reattach the armchair as required.
Ground-mounted installation ('M' version):
Prepare the ground with a hole circa 40 cm in diameter
to a frost-free depth. Fill the hole with frost-resistant
material so that the hole is not deeper than 50 cm. Turn
the armchair upright and position the supporting post in
the hole. Ensure that the armchair seat is level in
position and is level on all sides. The distance between
the seat's front edge and the ground beneath should be
45 cm. The supporting post should be cast in the
concrete, leaving a gap of 5 cm between the top of the
concrete and the ground surface to be filled in with
surface material.
Parco
sid 1/7