J3 Internal SCSI Connector Adapter Quick Installation Introduction The BusLogic PC/AT SCSI BT-540CF and BT-545C (BT- 54XC) Host Adapters are intelligent ISA to SCSI bus master host adapters, supporting up to seven SCSI de- vices. They offer driver support for widely-used stan- dard operating systems.
Port Address do not conflict with other installed cards. Figure 3. BT-54XC Switch Detail Edge Connedor Address 330. Check for is factory-shipped with Port conflicts with other cards. Figure 2. BT-540CF Board Layout card BIOS in the system must have enabled. by default the BT+IXC’s...
Page 4
7. Reassemble the host computer as described in the Step 5. Installing and Cabling the Adapter system owner’s manual. Remove the mounting screw and the existing 8. Power up the system. bracket from the rear panel behind the 16-bit slot where you want to install the BT-54XC.
BIOS Supports > 2 Drives (DOS 5.0 or Above). Host Adapter SCSI Terminators ON. Use This this option option turns on BIOS support for more than two hard to set adapter SCSI termination. Only terminators on devices at both ends of the SCSI chain should be turn4 disk devices on the SCSI bus.
3.11, installation is complete. Proceed to Step 5. For cxamplc, drivers supporting BusLogic SCSI hoht adapters arc embedded in NctWarc ~3.12 and 4.X. system for the first time, you will need to contin- You will need to install drivclrs when going ue with operating system installation.
If damage to the board has occurred, return it in the protective envelope and original packaging with this manual to your BusLogic board supplier. The shipping agent should also be notified if the unit has been dam- aged during shipment.