Absima Revenge CTM Series Quick Start Manual

Absima « Reve
Thank you that you have chosen a product of the "Revenge CTM" series. Here you get a high quality competition
Please read the instructions carefully. By using this product you agree to the terms of the warranty of Absima
Make sure that the motor temperature does not exceed 80°C, fit the reduction ratio of the engine when it is too hot
mounting the motor, pay attention tot he correct length of screws and not to over tight them with to excessive torque force.
The screws should not protrude more than 5mm in the motor housing as this could damage the motor winding.
Damage caused by excessively long screws will not be covered by the warranty.
Please note that the solder connections are marked A, B and C and connect the motor to the controller as described. During the
soldering process, ensure that the connections are not shorted by solder to each other.
Clean your Revenge Motor regularly in the area of ball bearings with brush and oils tot he ball bearings with suitable ball bearing
By the gear ratio you can see based on the temperature if the engine is operating effectively, the temperature should never
exceed 80°C. Approach slowly to the right gear ratio to avoid damage of the motor.
On the side of the motor is a scale where you can see the position of the timing. By loosening the rear screws you can twist the
An increase of the timing brings automatically an increase of the temperature. This depends on both, the timing that is on the
motor, as well as the timing, which is simulated with the controller. Please make sure that you be very careful with the
Approved for:
Part no.:
Turns:
RPM-V:
Power:
Current A:
Efficiency:
Voltage:
Poles:
Sensor:
Adjust. timing:
Ø w/o fins:
Shaft diameter:
(Competition Team Motor)
product, developed by racers for racers, to win races.
Precautions & Warnings
Read these instructions carefully before using your new motor!
Cleaning & Maintenance
Gear Ratio & Timing
adjustment of the timings etc.
Technical Information
2130040
2130044
1750 KV 1900 KV
1750 1900
1670W 1850W
110A 120A
88% 88%
4-6S 4-6S
4 Pole 4 Pole
GmbH.
Assembly
oil.
.
timing shield
Attention:
1:8 Scale*
2130041 2130042
2100 KV 2300 KV
2100
2070W 2100W
125A
88%
4-6S
4 Pole 4 Pole
Yes
Yes
42mm
5mm / Module 1
»
2130043
2500 KV
2300 2500
2650W
145A 160A
88% 86%
4-6S 3-4S
4 Pole
.
When