Clas Ohlson TX009LD2 Instruction Manual

Freestanding Letterbox
Art.no 31-5131 Model TX009LD2
Please read the entire instruction manual before using the product
and then save it for future reference. We reserve the right for
any errors in text or images and any necessary changes made
to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
Installation
1. Fasten the four included
ground anchor bolts onto
the base of the letter box.
Fasten the bolts in such
a way that you can adjust
the letter box up and down.
2. Dig a 30 cm deep hole in the ground where the letter box is
to be located.
3. Fill the hole in the ground with concrete.
4. Lay a couple of planks over
the hole and stand the letter
box on the planks so that
the lower ends of the bolts
stick down into the concrete
up to the threads.
5. Use a spirit level to try and stand the letter box as vertical
as possible. Fine-adjustments can be made later using
the nuts on the ground anchor bolts.
6. Leave the concrete to dry for 24 hours before removing
the planks.
7. Check the level of the letter box and adjust if necessary
using the nuts on the ground anchor bolts.
GREAT BRITAIN • customer service tel: 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk postal 10 – 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZ
Shelf
Place the sloping shelf in the desired position, there are three
heights to choose from.
Care and maintenance
Clean the letter box by wiping it with a damp cloth. Use only
mild cleaning agents, never solvents or corrosive chemicals.
Responsible disposal
The product should be disposed of in accordance with local
regulations. If you are unsure how to proceed, contact your
local council.
Specifications
Size 35 × 25 × 100 cm
Letter flap size 22 × 6 cm