Panasonic SL-SW940S Operating Instructions

This manual was printed with soy based ink.
p
P PC
Panasonic Consumer Electronics Company,
Division of Matsushita Electric Corporation of America
One Panasonic Way Secaucus, New Jersey 07094 http://www.panasonic.com
Panasonic Sales Company,
Division of Matsushita Electric of Puerto Rico, Inc. ("PSC")
Ave. 65 de Infantería, Km. 9.5 San Gabriel Industrial Park, Carolina, Puerto Rico 00985

Troubleshooting guide

Before requesting service, make the following checks. If you are in doubt about some of the check
points, or if the remedies indicated in the chart do not solve the problem:
In the U.S.A., contact the Panasonic Customer Call Center at 1-800-211-7262, or e-mail
consumerproducts@panasonic.com, or the website (http://www.panasonic.com).
In Canada, contact Panasonic Canada Inc. Customer Care Centre at 905-624-5505, or visit the
website (www.panasonic.ca), or an authorized Servicentre close to you.
≥The HOLD function is on ( ➪ abobe).
≥The disc isn't correctly set.
≥The disc is scratched or dirty.(Tracks skipped.)
No play.
≥There is moisture on the lens. Wait for about an hour and then try again.
≥The lens is dirty: clean it with a blower (recommended
product: SZZP1038C).If the lens gets marked with
fingerprints, gently wipe them off with a cotton swab.
≥Ensure the plugs are inserted firmly.
≥Wipe the plugs clean with a clean cloth.
No sound or there is
≥The elapsed playing time disappears and sound is interrupted
a lot of noise.
if bumps continue repeatedly.
≥Separate this unit from mobile telephones.
Play doesn't resume
≥This doesn't work if you open the lid while the unit is in the stop mode.
from the track where
≥This doesn't work during random play.
play stopped at.
≥It may not work correctly under some conditions.
≥Random play modes may be on ( ➪ page 4).
Play doesn't start
≥Play resumes from the track where you last stopped play or power
from the first track.
was cut off (play may start from a different track if you change discs
after power is cut off). Use skip to return to the first track.
Disconnect then reconnect all power sources (batteries and AC adaptor).
The unit stops working.
≥You aren't using the special rechargeable batteries ( ➪ page 3).
Cannot recharge.
≥You must insert two batteries before you can recharge them.
≥The unit must be off before you can recharge.
The AC adaptor becomes
This is normal.
warm during recharging.
The battery indicator continues to The battery indicator scrolls for about 6 hours regardless of the
scrool even if sufficiently charged.
amount of charge left in the battery.
Play time is very short The batteries have reached the end of their service life. Usually
they can be recharged 300 times.
even after recharging.
≥This may occur after the first time you recharge the batteries or after you haven't
used them for a long time. Play time should be restored after a few recharges.
Play time is short
≥The batteries can go flat if you leave the AC adaptor
after recharging.
connected after recharging is complete.
The battery indicator fails
≥The indicator does not appear when the AC adaptor is connected.
to appear or is incorrect.
≥The indicator does not appear correctly under some conditions.
Model No.
SL-SW940
SL-SW941C
Dear Customer
Thank you for purchasing this product. Before connecting, operating or
adjusting this product, please read these instructions completely. Please
save this manual for future reference.
The model number and serial
number of this product can be
found on either the back or the
bottom of the unit.
This function causes the unit to ignore accidental button presses.
Set to HOLD so the unit doesn't power on accidentally or play is interrupted.
Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and CD-RW that have been
finalized upon completion of recording. It may not be able to play some
§
CD-R or CD-RW due to the condition of the recording.
§Finalizing is a process that enables CD-R/CD-RW players to play audio
CD-R and CD-RW.

Resume function

The player stores the track where you stopped play or power was cut off.
Opening the lid when the unit is in stop mode cancels the function.
Auto power off function
If the unit is left in stop mode for approximately 10 minutes, the unit powers
itself off automatically.
Panasonic Canada Inc.
5770 Ambler Drive, Mississauga, Ontario L4W 2T3 www.panasonic.ca
C 2003 Matsushita Electric Industrial Co., Ltd.
Printed in Japan
Display
The HOLD function is on ( ➪ above).
(
≥You haven't inserted a disc or it isn't inserted correctly.
)
≥You have inserted a disc this unit cannot play.
* The disc lid is open.
' Full: The program already contains 20 tracks.

Specifications

Audio
No. of channels:
2 (left and right, stereo)
Frequency response:
20 to 20,000 Hz
(i0 dB to j7 dB)
DA converter: 1 bit, MASH
Headphone output level:
RMS max. 6 mWi6 mW/
16 ≠ (adjustable)
Pickup
Light source: Semiconductor laser
Wavelength:
General
Power supply:
DC input (via optional AC adaptor):
Operational temperature range:
0 eC–40 eC
(32 eF–104 eF)
Rechargeable temperature range:
5 eC–40 eC
(41 eF–104 eF)
1
Portable CD player
Operating Instructions
Please note them in the space
provided below and keep for
future reference.
MODEL NUMBER
SERIAL NUMBER
HOLD
Play time:
[Approximate operating time in hours
(in hold mode with EQ canceled, at 25
eC (77 eF) on a flat, stable surface)]
Batteries
used
2 optional
alkaline batteries
2 optional rechargeable
batteries
Recharging time:
780 nm
≥The play time may be less depending
on the operating conditions.
≥Play time will be considerably
reduced when playing CD-RW.
DC 4.5 V
Dimensions (WaHaD):
142a29.7a142 mm
(5 9 /
Mass:
(without batteries)
Note:
Specifications are subject to change
without notice.
Mass and dimensions are approximate.
RQT6781-P
F0103KN1023
Play time
33
15
About 6 hours
3 / 9 /
za1 za5 z)
16 16 16
320 g (11.3 oz.)
(with batteries)
280 g (9.9 oz.)