Universal Furniture EXPLORE HOME 475-920 Instruction Sheet

475/476-920/921/963/965/966
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
# Description
A Middle back panel
C Left pier
E Entertainment Hutch
G Shelf glass
Assembly Procedure
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Attach right pier (B) and left pier (C) to middle back panel (A) with allen head bolt (1) using
allen wrench (4) from the hardware pack (H). Then attach hutch top (D) to right pier (B) and
left pier (C) with dowels (3) and screw up with screws (2).
Step 3: Place the entertainment hutch (E) onto the entertainment console (F) and screw up with
screws (2) from back side as below shown.
Step 4: Install shelf glass (G) with shelf pin (5).
Note: It is best two or more persons are involved.
Assembly is now complete.
INSTRUCTION SHEET
Qty. #
1pc B
1pc D
1pc F
6pcs H
: (Please follow the sketches below.)
Page 1 of 4
Entertainment Wall
Description
Right pier
Hutch top
Entertainment console
Hardware pack
Qty.
1pc
1pc
1pc
1bag