Guimbal CABRI G2 Flight Manual page 69

Hélicoptères Guimbal
CABRI G2
Station 4 :
Tripod attachments .................................................................... Check
Tail gearbox oil level .................... Check – Minimum is mid-sight gage
Chip detector ............................................................................ Locked
Pitch lever and rod end ............................................... Check free-play
Horizontal stabilizer ................................................................... Check
Rear transmission tube ........................ Check while turning main rotor
Right tail boom side general condition ............................... No damage
Transmission bearings bolts and plugs.............................. Check tight
Station 5 :
Muffler exhaust ......................................................... Check and shake
Right cowling hinge.................................................................... Check
Open the right engine cowling
Right tail boom attachments .................................................. No crack
Cotter pins .............................................................................. Installed
Muffler ............................... No crack or interference with engine frame
Oil filter ....................................................................... Locked, no leak
Engine oil dipstick ..................................... Check 4 to 6 Qt and tighten
Engine mount condition ....................... Inspect for cracks or corrosion
Fuel line condition ...................................................................... Check
Clutch distributor and attachment ................................... Tight, no leak
Oil cooler pipes ........................................................................ No leak
VHF antenna ............................................................................. Check
Engine cooling intake screen ................................... Inspect and clean
Winter air flow restrictor ............................................. check if installed
Ignition wires .............................................................................. Check
Engine and baffling general condition ........................................ Check
Rotor brake ................................................ Check pads and clearance
Flex coupling and bolts ............................................... Tight – no crack
Upper pulley .............................................................................. Check
Clutch actuator ..................................................................... Retracted
Main gearbox oil level .................. Check – Minimum is mid-sight gage
Chip detector ............................................................................ Locked
Inspection door ......................................................................... Closed
Engine skirts condition and attachment ..................................... Check
Exhaust pipes ............................................................................ Check
Carburetor heating hose ............................................................ Check
Air intake duct and hose ............................................................ Check
Gascolator drain ...................................................................... Sample
Fuel flow sender ........................................................................ Check
Aft landing gear attachment ....................................................... Check
Cowling ..................................................... Close and lock both latches
Front and main gear bow condition ........................................... Check
Landing gear pants and skid condition ...................................... Check
Issue 07
Original issue
NORMAL PROCEDURES
EASA Approved
SECTION 4
4-5