Hélicoptères Guimbal
CABRI G2
Parameter
CHT
Oil T
6.6< 7.9 bar
(95< 115 psi)
Oil P
1.7 <
(25 <
Fuel P
Original issue
Issue 09.3
Exceeds
• If in hover, land or depart in translation
• If in translation, reduce power
Red arc
Once landed, keep nominal NR for cooling
• If in hover, land or depart in translation
• If in translation, reduce power
Red arc
Once landed, keep nominal NR for cooling.
Wait to apply full power
Yellow arc
Allow to warm-up.
• Cold starting : allow engine to warm-up
Red arc
• Flight : reduce power
> 7.9 bar
If stays into red arc :
(115 PSI)
• Normal at cold starting and during engine
warm-up,
Yellow arc
• Flight : reduce power.
If stays into yellow arc :
• Normal at idle,
Yellow arc
• Flight : CLUTCH light should light soon
3.6 bar
52 psi)
after. Refer to p 3-16 – CLUTCH.
Red arc
< 1.7bar
Monitor OIL P warning light.
(25 PSI)
Red arc
1. Check boost pump ON
< 0.03 bar
2. Reduce power and reach Vy = 50 kt IAS
(0.5 PSI)
Red arc
1. Switch boost pump OFF
> 0.55 bar
2. Check a decrease
(8 PSI)
EMERGENCY PROCEDURES
Corrective actions
If indication stays into red arc,
LAND AS SOON AS POSSIBLE
If indication stays into red arc,
LAND AS SOON AS POSSIBLE
LAND AS SOON AS POSSIBLE
LAND AS SOON AS POSSIBLE
LAND AS SOON AS POSSIBLE
If ON
LAND IMMEDIATELY
LAND AS SOON AS POSSIBLE
LAND AS SOON AS POSSIBLE
EASA Approved
SECTION 3
3-13
Need help?
Do you have a question about the CABRI G2 and is the answer not in the manual?