Guimbal CABRI G2 Flight Manual page 56

Hélicoptères Guimbal
CABRI G2
MLI failure :
Detected by the indication
1. Above 5500 feet Zp, you will always be limited by full throttle,
Below 5500 feet Zp, do not exceed 80 kt IAS in level flight to
prevent overpower.
CONTINUE FLIGHT
2. Make a cautious landing in conditions requiring not more power
than previous take-off.
MLI degraded modes :
In case of one of following parameters loss, the MLI shifts automatically to a
degraded mode :
•
Engine speed,
•
Throttle position,
•
OAT,
•
Ambiant air pressure.
Degraded mode is signaled by the MLI indication displayed in yellow.
CONTINUE FLIGHT
EPM CPU overtemperature failure :
When overtemperature is detected, the EPM displays this warning, then
shuts down 30 seconds later.
Refer to Complete loss of EPM display procedure.
If conditions for overtemperature have disappeared, a restart can be
attempted : wait for a low workload moment in stabilized flight, switch ALT.
OFF, then switch Master OFF for a short moment, then ALT. ON again.
3-10
XXX on MLI
EASA Approved
EMERGENCY PROCEDURES
SECTION 3
Original issue Issue 09