Oakton Environmental Express 35660-60 Instruction Manual

* "DO" is an abbreviation of Dissolved Oxygen.
Conformable standards

This equipment conforms to the following standards:
RoHS: EN50581
9. Monitoring and control instruments
Authorised representative in EU

Cole-Parmer UK
9 Orion Court, Ambuscade Road
Colmworth Business Park
St Neots
Cambridgeshire
PE19 8YX, United Kingdom
Phone: +44-(0)1480-272279
Fax: +44-(0)1480-212111
Cautions during handling

CAUTION
Chemical solution
Highly concentrated potassium hydroxide (KOH) is used in the
internal solution of the electrode.
If the internal solution in the electrode comes in contact with your
hands or skin, wash immediately with water. If the internal solution
comes in contact with your eyes, flush immediately with large
amounts of water and seek treatment by a physician.
 Do not allow the electrode to be in contact with any hard
surface.
 An extremely thin membrane is stretched across the DO
tip and the DO responsive part. Do not allow the
membrane to come in contact with any hard surface and
do not exert undue force on the diaphragm.
 When attaching the DO tip to the electrode body, make
sure that the O-ring is attached. Attach the DO tip
securely to the electrode body.
 The electrode connector requires a high degree of
insulation.
Do not allow the connector to be in contact with water or
dirty hands.
 DO tips that are no longer usable should be disposed of
as industrial waste.
 The water-resistant construction of meters can be used
in construction (conforming to IP-67). When measuring,
do not immerse the cap, the lead or connector in the
sample.
Packaged contents

Name
Holder
DO tip (35660-64)
Instruction Manual
Oakton Instruments
625 E. Bunker Ct. Vernon Hills, IL. 60061, USA
E-mail: info@4oakton.com
Phone number: (1)888-462-5866
DO Electrode (35660-60 / 35660-62)
Instruction Manual
Q'ty
1 pc.
1 pc.
1 copy
CODE:M003859-3200839731-GZ0000590188
Specifications and names of parts

 Names of parts
Electrode connector
Temp. connector
(T electrode)
Protective
cap
O-ring
Temp. sensor
 Specifications
Model
Measurement method
Measurement range
Temperature range
Wetted materials
Electrode size
Lead cable length
Preparations

Connecting to meter

1. Insert the electrode connector into the connector port
sleeve on the meter, after aligning with the pin. Do not
insert the connector unless it is aligned properly with the
connector port.
2. Press the electrode connector into the connector port on
the meter, while turning the connector to the right.
3. Slide the connector cover over the connector. Then,
push the cover in straight until it comes in light contact
with the meter case.
Do not turn the cover.
4. Insert the temperature connector into the jack on the
meter. Insert the connector firmly, until the O-ring on the
connector can no longer be seen.
③
For any questions regarding this product, please contact your local agency,
or inquire from the following website.
http://www.4oakton.com/
December, 2019
Connector cover
Holder
Cap
Lead
35660-60, 35660-62
Membrane galvanic cell
0 to 20 mg/L
0 to 50°C
Holder： PC/ABS
DO tip： PPS,FEP
Protective cap： SCS-14
φ30 × 165 mm
2 m (35660-60)
5 m (35660-62)
②
①
④