Page 1
Programming further internal intercom units: repeat steps 2 and 3 respectively Briefly press the programming button on the BVS20 control unit → the LED lights up permanently → Programming mode OFF PKA TC BVS20 e...
Page 2
An intercom call button can be linked with the serial numbers of two different internal intercom units. As a result these two indoor intercom units will ring at the same time in parallel. Briefly press the programming button on the BVS20 control unit → the LED flashes → Programming mode ON...
Page 3
→ Programming mode ON Press and hold the call button…..until the second confirmation tone is heard (for approximately 6 seconds) Briefly press the programming button on the BVS20 control unit → the LED lights up permanently → Programming mode OFF...
Page 4
→ the display LED flashes permanently (min. 0.8 s, max. 5 min). Service René Koch AG If you have any questions, please contact Seestrasse 241 8804 Au/Wädenswil our technical customer service team 044 782 6000...