PCS – Pressure Control System
Leaflet for Quick Start - Valid for all versions
Set the pressure points
Mode/Function
Measurement mode
After switching on, after
about 5 seconds the
pressure switch is in the
measurement mode.
Pressure point P_1
o
with
change
o
pressure point P_2
with
change
Menu
with
select
and with
confirm
Keys lock
with
select
and with
confirm
Commissioning
-
Connect the compressed air
(Plug-in connector with hose connection ø6/4mm)
-
Connect the power supply and signal cables acc. to the
terminal connection diagram
-
Set the pressure points, if different than the
Status at delivery (see reverse side)
ATTENTION: The technical safety instructions in the operating manual must imperatively be
observed! Read carefully before the commissioning the complete operating and installation
manual Failure to comply will void the warranty!
digital display
1
Air supply Hose connection.ø6/4mm
2
Pressure gauge for the control pressure of the actuator
3
Throttle for the control pressure of the actuator
4
Infeed air throttle for setting the rotational speed
5
Discharge air throttle for setting the rotational speed
6
Potentiometer for setting the pulse width
7
Position indicator
8
Terminal zone for power supply and signal cable
9
Cable connection M20x1,5
10
LEDs for status indication
11
Jumper socket J1-J7
12
Valve block with Manual override
13
Digital pressure switch
1)
- Only for version PCS-U-...
Mode/Function
F0 – phyical unit
with
select
and with
confirm
F01 / F02
Set the pressure points
Select output 1 or 2
Set the pressure
points P_1
and
O
P_2
O
Set the hysteresis
P_1 / P_2
for
O
P_1
- H_1 = P_1
U
F81 - PIN
– Query at
unlocking the key lock.
witching on/off
S
with
and with
confirm
PCS-U
1)
1)
1)
PCS-E-...-M
1)