Page 2
Dear customer, thank you for purchasing one of the quality products produced by TechniSat. In order to ensure that the quality of the product remains constant over many years, both the dish and the mounting bracket are made of aluminium. Please read the installation instructions carefully befor4e proceeding with the instal- lation, to ensure that you can enjoy optimum reception performance after installation.
Mounting the external unit When you unpack the external unit, you will find that it has already been partly pre-assembled, so all you need to do is to mount the dish (item 2) and the connector piece (item 3). First, use the screws (A) to attach the dish to the AZ/EL bracket (item 1).
The positioning of the external unit should preferably be done with the aid of a calibration tool. Alterna- tively, positioning can also be effected with the aid of the less expensive TechniSat SatFinder (Article No. 0000/3045). If neither of these aids is available, positioning can be carried out as follows, using a digital receiver and a television set.
Page 5
The offset angle of the DigiDish 33 resp. the DigiDish 45 is 30°. Therefore, if you are in Daun and using a DigiDish 33 resp. 45, this results in an angle of: 31,29° - 30° = 1,29° Loosen the screws (D) on the swivel profile so that you can move the external unit up or down.
Page 6
In order to receive the programmes of all 4 satellite positions via your digital receiver, you must pro- gramme these satellite positions in the antenna settings of your receiver, as per the operating manual of your receiver. Position/Option Switching criterion Satellite Astra 19,2°...
Page 7
Sealing the LNB connection Dear customer, in order to prevent any moisture from entering the Multytenne LNB, please use the self-sealing duct tape supplied to insulate and seal the LNB connection. First remove the foil from the sealing tape. Apply one end of the sealing tape approx. 1-2 cm below the F-connector. Now stretch the sealing tape as much as possible, and wrap it around the co-axial cable and the F-connector, with overlapping edges.
Page 8
This product bears the CE symbol, and complies with all relevant EU standards. Subject to change without prior notice, not responsible for printing errors. Correct as at 10/04 DigiDish and TechniSat are registered trademarks of TechniSat Digital GmbH Postfach 560 – D-54541 Daun/Germany www.technisat.com...