Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for QEP Vitrex LRS600
- Page 1 User Manual Long Reach Sander LRS600 (230v) & LRS600IND (110v) Page 1 of 8...
-
Page 2: Product Description
PRODUCT DESCRIPTION The machine is designed for sanding drywalls, ceilings and walls of the inner and outer surfaces, clearing the floor residues, paint coatings, adhesive and loose plaster etc. Our machine is not suitable for processing the object containing asbestos. You must abide by certain safety precautions when using the equipment. -
Page 3: General Safety Rules
Always check if your mains voltage corresponds with the value on the type plate The machine has been double-insulated in accordance with EN60745: therefore, an earth wire is not necessary USE CORRECT SUPPLY VOLTAGE: The power supply voltage must match the information quoted on the tools identification plate. - Page 4 Power tool use and care Do not force the power tool. Use the correct power tool for your application. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
- Page 5 6.1 Installation - Unfold the machine and fasten the handle.(See Fig.1-1,Fig1-2 and Fig1-3). Strip the machine by the opposite actions. Fit the screw to the groove; Lock on by fastening block; Finish installation; Strip the machine by the opposite actions. NOTE: If find the fastening block too tight or to loose to lock the handle, please adjust the fitting screw to be looser or tighter by hand! -Stick the sanding paper to the pad(Fig.2)
- Page 6 6.2. Electronic Control This machine has the characteristics as below ： On/Off Switch with soft start Ensure machine starts smoothly without wobbling. Adjustable Speed Adjust the speed from 0-1000rpm by turning the speed wheel (Fig.5) In this way, user can choose different speed for different sanding surface.
-
Page 7: Care And Maintenance
Inhalation of dust is hazardous to health! When carrying out the work which can produce dust, please always wear a dust mask. Loose the fastening nut. Connect the hose to the exit of the handle (Fig.9) The other end of the hose is connected to the vacuum cleaner;... - Page 8 For your own safety, never remove parts or accessories of the electric tool during operation. In case of fault or damage have the electric tool repaired only by a specialist workshop or by the manufacturer. For your personal safety, READ and UNDERSTAND before using. Save This Instruction For Future Reference Always Wear Ear Protection With This Tool Always Wear Eye Protection With This Tool...