Download Print this page
Pentair Pool Products FIBERworks 20100100 Owner's Manual
Pentair Pool Products FIBERworks 20100100 Owner's Manual

Pentair Pool Products FIBERworks 20100100 Owner's Manual

Advertisement

Quick Links

READ AND FOLLOW ALL INSTRUCTIONS
Table of Contents
SECTION I.
SECTION II.
SECTION III.
Warranty ................................................................................... 4
Read and follow all warning notices and instructions accompanying this product. Failure to follow safety warnings
and instructions can result in severe injury, death, or property damage. Call (800) 831-7133 for additional free copies
of this manual.
Attention Installer.
This manual contains important information about the installation, operation and safe use of this
product. This information should be given to the owner/operator of this equipment.
Pentair Pool Products
1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151
10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400
Rev. F 5-02-01
FIBER
works
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Operating the Photon Generator ................... 2
Troubleshooting ............................................ 2
Replacing the Bulb ........................................ 3
Important Notice
Owner's Manual
WARNING
1
P/N 99293200

Advertisement

loading

Summary of Contents for Pentair Pool Products FIBERworks 20100100

  • Page 1 This manual contains important information about the installation, operation and safe use of this product. This information should be given to the owner/operator of this equipment. Pentair Pool Products 1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 Rev.
  • Page 2 SECTION I. Operating the Photon Generator If you have a white light only model (P/N 20100100) There is only one switch located on the back of this unit. Push it once to turn the power on and again to turn it off. If you have a standard color wheel model (P/N 20100200) There are two switches on the back of the Photon Generator.
  • Page 3 SECTION III. Replacing the Bulb Bulb replacement in the FIBERworks Photon Generator is the easiest available! There are no screws to remove and lose, or plugs to pull, and a spare bulb can always be kept handy, right inside the unit. To change the bulb: Figure 1 •...
  • Page 4 Pentair Pool Products will at its option, repair or replace such item or part at its own cost, and expense.

This manual is also suitable for:

Fiberworks 20100200Fiberworks 20100300Fiberworks 20100400