Vicenza Designs TP9000S Instructions For Installation

Product(s): TP9000S,
TP9001S, TP9002S, TP9003S,
TP9004S, TP9005S, TP9006S,
TP9007S
Rev: 21Aug12
INCLUDED PARTS
A. TP holder bases (2)
B. TP holder spring (1)
C. Mounting brackets (2)
D. Screws (4)
E. Wall anchors (4)
F. Allen wrench (1)
G. Set screws - installed (2)
MOUNTING INSTRUCTIONS ON DRYWALL
1. Determine the desired location for the TP holder.
2. Insert the TP holder spring (B) into the TP holder bases (A) without tightening the set screws (G).
Hold the entire assembly to the wall, and mark the position of both TP holder bases.
3. Place one mounting bracket (C) on the wall (inside where you marked the TP holder base position)
and mark the location of the two screw holes.
4. Drill 5/8" holes in the wall.
5. Repeat this operation for the other mounting bracket, using a carpenter's level to ensure that the
TP holder will be level.
6. Place two of the screws (D) through one of the mounting brackets and attach wall anchors (E) to
the screws. Push the wall anchors through the wall, and tighten the mounting bracket to the wall by
tightening the screws. Pulling the mounting bracket away from the wall help secure the wall anchors
while tightening the screws.
7. Repeat the previous step for the other mounting bracket.
8. Attach each TP holder base to the installed mounting brackets and tighten the set screw, using
the enclosed allen wrench (F). Be careful to not over-tighten the set screw
9. Install paper onto the spring and insert the TP holder spring (B) into the TP holders.
Note:
Although basic mounting hardware is included, be sure to use the proper mounting hardware for your wall type.
If unsure, consult your local hardware store. Attaching the mounting brackets to wall studs or to backing made of 1x2 or 2x4
is the best method for mounting your new hardware.
CARE
Clean only with a soft, dry cloth. To protect the finish, we do not recommend the use of polishes or
abrasives. If you have any questions regarding your Vicenza product, please contact your local dealer.
Headquarters: 4675 Vandenberg Dr., N. Las Vegas, NV 89081 • (800) 932-2358 or (702) 651-1304 • Fax (702) 651-1303
INSTRUCTIONS FOR INSTALLATION
www.VicenzaDesigns.com
San Michele
TP9000S