DATE ISSUED:
December 2014
MODELS EFFECTED: CS and LG Series
STEP 1
Press "power" button to activate the control. The
setpoint temp will show up and will either be 450, 350
or 375. This determines which program column
numbers to use.
STEP 3
Use the "up arrow" to change the flashing number on
the left to the number or letter needing to be changed.
(variables are numbers 0 - 9 and then letters A - S)
NOTE:
ignore the changing numbers on the right.
STEP 5
Use the up or down temp arrows to change the number
on the right to the desired number.
STEP 2
Press and hold the "Prime" and "Temp" buttons together, count to
6 or wait until the display reads 0 on the left (this is variable "0").
The "0" will be flashing. The number on the right will either be
25 or 30
STEP 4
When you reach the number/ letter to be changed, press and
release quickly, the "Prime" button once. The number/letter on the
left and the 4 blue dots will be flashing. While the 4 blue dots are
flashing, the number on the right can be changed using the temp
arrows.
STEP 6
Press the "Prime" button once, quickly, the number/letter on the
left will stay flashing, and the four blue lights will go off.
* If necessary, cycle to the number/letter on the left to the next
variable needing to be changed, and repeat steps 3 thru 6.
* If no other variables need to be changed move to step 7
Digital Control Center
"How To Confirm Program
Part Number: 50125
"