Advertisement
Quick Links
Instructions/Parts
Zephyr
and Stand
For use with waterborne paints only.
Not for use in explosive atmospheres.
175 psi (1.2 MPa, 12 bar) Maximum Working Pressure - Gun
125 psi (0.9 MPa, 9 bar) Maximum Working Pressure - Stand
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
Model 289054
Ref. Part No. Description
1
289054 GUN, drying
1a
289058 DIFFUSER
1b*
-----
FILTER
2
289055 STAND, drying gun
Not sold individually.
---
* Order Kit 289057 for replacement filters,
five (5) per pack.
™
Drying Gun
1a
1b
1
ti12162a
Qty
1
1
1
1
1
2
Kit 289056
(Includes two guns and one stand)
313434A
ti12164a
Advertisement
Related Manuals for Graco Zephyr
Summary of Contents for Graco Zephyr
- Page 1 Instructions/Parts ™ Zephyr Drying Gun and Stand 313434A For use with waterborne paints only. Not for use in explosive atmospheres. 175 psi (1.2 MPa, 12 bar) Maximum Working Pressure - Gun 125 psi (0.9 MPa, 9 bar) Maximum Working Pressure - Stand Important Safety Instructions Read all warnings and instructions in this manual.
- Page 2 Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equip- ment. The exclamation point symbol alerts you to a general warning and the hazard symbol refers to procedure-specific risk. Refer back to these warnings. Additional, product-specific warnings may be found throughout the body of this manual where applicable.
- Page 3 Assemble Stand Assemble Stand 1. Attach legs (2a) and center pole (2c) to the stand base (2b). Adjust height as needed, from 8-83 in. (20 - 210 cm). 2. Put the main air manifold (2d) and the mounting bar bracket (2e) on the center pole (2c) at desired height.
- Page 4 Installation and Operation Installation and Operation 4. Use a rag moistened in solvent to wipe out- side of gun body (1) and diffuser (1a). 1. To use stand: Assemble stand and adjust stand height and direction as necessary. See Assemble Stand, page 3. 2.
-
Page 5: Technical Data
Weight (with male inlet fitting) ..... . 484.3 g (19.4 oz) Zephyr Gun Flow Rate vs. Inlet Pressure * All readings were taken with the air shut-off valve fully open at the assumed operator position. -
Page 6: Graco Standard Warranty
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.