Champlain ACM-182 Instructions

1) Power Button (ON/OFF/LIGHTS):
• Press and hold for 3 seconds to power "ON" the speaker.
• Press again to turn on lights. Press to change light colour.
• Press to power "OFF" the speaker.
2) V- Button (Lower Volume/Replay Song):
• Press once to turn volume down.
• Press and hold to play previous song.
3) V+ Button (Raise Volume/Play Next Song):
• Press once to turn volume up.
• Press and hold to play next song.
4) Play/Pause Button:
A) Press once to:
• Play or pause music;
• Connect to an incoming call;
• Hang up phone conversation.
B) When Bluetooth is paired to a mobile device, press twice
to redial last phone number.
C) Press and hold to disconnect incoming call.
D) Press and hold for 2 seconds to disconnect Bluetooth.
E) Press and hold for 5 seconds to reset to factory settings
and clear all pairing settings.
5) LED Indicators:
• Blue LED Light: blinks while pairing and stays lit after
successful connection.
• Red LED Light: Blinks when battery is low, stays lit while
charging, turns off when fully charged.
6) Charging Port:
Connect the micro USB to the speaker and the USB to any
USB 5V/2A charger. The Red LED Light stays lit while charging,
turns off when fully charged.
Bluetooth version: V4.2
Battery capacity: 1800mAh
Power supply: DC 5V/2A
Frequency response: 115Hz-16KHz
Receiving range: ≤65 feet (open field)
Charging port: Micro USB
Charging time: 3-4 hours
Bluetooth Pairing:
A. Turn speaker ON, the Blue LED Light (5) will flash while waiting
for device connection.
B. Go to "Bluetooth" settings on your device, select D3 and
connect. When pairing is successful speaker will chime and Blue
LED Light (5) will remain lit.
TWS Bluetooth Pairing:
If you already have 2pcs D3 speaker, you can pair TWS (Note: you
only have to do the TWS pairing the first time):
A. Connect the TWS for the first time, disconnect all Bluetooth
pairing between the speakers and your device and turn two D3
speakers off.
B. Turn ON both speakers, then double press the Power button on
one speaker, the speaker will chime.
C. At this point, the two speakers are in TWS pairing mode.
D. Two speakers will be paired automatically under the TWS mode.
Speakers will chime once pairing is successful. The Blue LED
Light (5) will stay lit on one speaker (this will be the
RIGHT/SLAVE speaker); the Blue LED Light (5) will blink on the
other speaker (this will be the LEFT/MAIN speaker).
E. Go to "Bluetooth" settings on your device, select D3 and
connect.
F. When you turn OFF one speaker, the other speaker will turn OFF
simultaneously.
NOTE: Either speaker can receive an incoming phone call, but only
the MAIN (blinking Blue LED Light) speaker will talk.
Includes:
USB charging cable;
Instruction sheet.
SPECIFICATIONS:
Rated power: 5W
Waterproof: IPX7
Driver unit: 4Ω5W/53mm
Playing time: up to 10 hours
(@65dB SPL)