BRIGHTLIGHT BL-LS-4300-30 Installation Manual

ENCAPSULATED LED RIBBON | LITE
COLOUR CODE LUMENS
WARM WHITE
BL-LS-4300-30 ≥180lm/m
3000K
NATURAL WHITE
BL-LS-4300-40 ≥250lm/m
4000K
LED WATTS 7.2W/m
INPUT VOLTS 24V DC constant voltage
OPERATING TEMP. -25°C ~ +60°C
MAX. RUN PER 15m using one feed
POWER FEED 30m using two feeds
DIMENSIONS W6 × H12mm
(W8mm for connectors)
CUTTING LENGTH 50mm
MINIMUM BEND 10mm
RADIUS
BEND DIRECTION Horizontal bending
BEAM ANGLE 115°
SOURCE LIFE 50,000 hours
WARRANTY 3 years
INGRESS Protection established by use of
PROTECTION IP65 connections
CONTROL Dimmable by PWM signal
Actual product characteristics may vary. Bright Light reserves the right to improve, modify or update the product designs without prior notice.
ENCAPSULATED LED RIBBON | LITE CAN BE CURVED AS SHOWN BELOW:
HORIZONTAL BENDING
LIGHT DIRECTION
DO NOT TWIST THE LIGHT OR BEND AGAINST THE LIGHT SURFACE
BRIGHT LIGHT RECOMMENDS CONNECTIONS ARE MADE IN-HOUSE
CUTTING RIBBON & CONNECTING BOOT CONNECTORS
SIDE A VIEW - CUT MARKS
1
TOP / LIGHT DIRECTION
50
TOP VIEW - EXPOSE SOLDER PADS
2A
CUT OUT NOTCH TO EXPOSE
SOLDER PADS
SIDE B VIEW - EXPOSE SOLDER PADS
2B
CUT OUT NOTCH TO EXPOSE SOLDER PADS
MINIMUM BEND RADIUS
10MM
CUT MARK
1. Cut Encapsulated LED Ribbon only 3. Cut and trim the cable to the appropriate length and feed
at the cut lines shown on Side A of
product.
2. To fit an end or bottom connector, cut 4. Insert silicone into connector before fitting over connection. The
out a notch (approx 3 × 3mm) from
Side B to expose the PCB solder
pads. Take care not to cut or damage
5. Shortening ribbon / fitting new end cap: Cut Encapsulated
the PCB and LEDs in this step.
SOLDER WIRES
3
INSTALLATION GUIDE
SAFETY NOTES
–
Before making any cuts, installation,
maintenance, or connection, be sure
6 the mains power is disconnected.
–
All connector joints must be connected
correctly to achieve connector IP rating.
–
Check the polarity of the connector
before inserting the front connector and
switching on the mains power.
–
Cut and connect Encapsulated
LED Ribbon correctly. Any incorrect
operation can cause damage.
–
Use a certified Bright Light 24V DC
power supply.
CROSS SECTION
SIDE A SIDE B
Cut mark are When connecting cable,
notch out from this side
visible on this side
through connector. Solder the wires onto the solder pads of the
Encapsulated LED Ribbon PCB ensuring the correct +/- polarity.
silicone is required to complete the IP65 rating. Failure to do this
will result in warranty becoming void.
LED Ribbon to length then fit end cap and silicone in place.
SILICONE CONNECTOR
4
ADD SILICONE
INTO CONNECTOR
BEFORE FITTING
0800 952 000 | www.brightlight.co.nz | BRIGHTLIGHT